Quick Start Guide

ManualsBrandsHitron Technologies ManualsElectronics24X8 P6 DBCC WiFi eMTA

Table Of Contents

QUICK START GUIDE

HITRON

CGNV5

Check the contents of the box

Read me

First!

Primero!

Step

Make sure you have the following:

Connect to the internet

Connect phone

CGNV5

CABLE ETHERNET

QUICK START GUIDE

Configure la red WiFi

P3300047CN17

Connect the coaxial cable to the connector

Connect power

STEP

Connect the coaxial cable from the cable outlet to the

connector of the device.

STEP

Connect the power adaptor to the power port and switch to

“ON”.

Connect the phone to the voice port

Connect your computer to the device

STEP

Use the phone cord to connec ypur phone to the Voice Port and

wait for a dial tone before using.

STEP

Use the Ethernet cable that comes with the device to connect

your computer to one of the LAN ports

User configuration (optional)

Connect your computer to the wireless network

STEP

Your device has a configuration interface that allows you to

fully control the behavior of the device. In a web browser,

enter the IP of the device in the address bar and make sure

that your PC is on the same subnet as deice. On the screen

that appears, enter the username and password.

Contraseña: #BBAADD@CCFFEE*

IP del dispositivo:

Modo Router: 192.168.1.1

Mode Bridge: 192.168.100.1

STEP

Connect the wireless devices with the correct SSID and password.

If they have not been changed, the default values are indicated on

the sticker on the back of the equipment.

Connect your wireless devise with WPS unction. Enter the setting interface

(refer to step 6), Enter the Wireless page to

Enable WPS and set the AES encryption mode,

then press Save changes.

Press this button to start the WPS Push Button

(PBC) setup process. Press on the PBC button of

your wireless clients within the coverage area

within the two minutes allowed to join the

wireless network.

Summary of content (4 pages)

PAGE 1
QUICK START GUIDE HITRON CGNV5 Check the contents of the box Read me First! Primero! Step Make sure you have the following: Connect to the internet CGNV5 Connect phone la red WiFi Connect theConfigure coaxial cable to the connector P3300047CN17 STEP Connect the coaxial cable from the cable outlet to the connector of the device. Connect the phone to the voice port STEP Use the phone cord to connec ypur phone to the Voice Port and wait for a dial tone before using.
PAGE 2
Installation complete STEP Congratulations! You have successfully configured your CGNV5. If you have a problem, see the next section for help identifying the cause. IP Address If the CGNV5 successfully connects to the network (see LED Panel) butt you cannot access the internet from a connected computer, it is possible that the IP address of your computer is not configured correctly.
PAGE 3
FCC STATEMENTS IC STATEMENTS FCC STATEMENTS UL and NOM-019 FCC STATEMENTS Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 4
cUL STATEMENTS FCC LISTED CAUTION: Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries According to the Instructions. The cable distribution system should be grounded (earthed) in accordance with ANSI / NFPA 70, National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable. Unambiguous reference to service documentation for instructions for replacement of fuses replaceable only by service personnel.