User's Manual

QUICK START GUIDE
CGNV22
Connect to the network
Connect your phone
Set up your Wireless network
Read me
first!
1
STEP
Check the box contents
Look in the box and make sure you have the following:
2
STEP
Connect the cable port
Connect your cable outlet to the device’s CABLE connector.
3
STEP
Connect the power
Connect the power adtaptor to the POWER port.
6
STEP
Connect wireless devices
To connect you device to the wireless network.Look at the sticker
at the bottom of the device, and make a note of the SSID and
Wireless PassPhrase, If you are using a smart phone or tablet you
could scan the QR code on the "WiFi" label. This will help you to
obtain the "WiFi" information quickly.
4
STEP
Connect your phone to the LINE port
Use the cable to connect your phone to the LINE port.
Wait for dial tone before using it.
5
STEP
Connect your computer to the device
You can use the included Ethernet cable to connect a computer to
one of the LAN ports.
For both cases, look at the LEDs ( ) on
the front of the device. If the light is on or
blinking, then WiFi is on.
QUICK START GUIDE
HITRON CGNV22
ETHERNET CABLE
POWER ADAPTER
SSID-2.4G: MOVISTAR_XXYY
Seguridad: WPA2-PSK
Contraseña: WWWWWWWWWWWWWWWWWWWW
CM RF MAC: A1234567890B
eMTA MAC: 1234567890AB
WAN MAC: 0987654321AB
WiFi
On your computer open the Wireless network connections and choose the
SSID of the Device you want to connect.
On the next window enter the PassPhrase
on your device label and press the Connect
botton. Once connected, please verify if
your computer is Connected to your Device’s
SSID.
If not,turn the Wireless network on by pressing the WPS button of the device for more
the 5 seconds.
If you want to use WPS function, press the WiFi/WPS botton for 1~ 5 seconds.