Wireless Module for IR COM User Manual Beijing Honghe Technology Group www.honghe-tech.
目录 RF Wireless Connection ............................................................................................................ 3 Application Installation and Uninstallation ............................................................................... 3 Application Installation ..................................................................................................... 3 Application Uninstallation .............................................................................................
RF Wireless Connection Step 1: Fix the Infrared WhiteBoard and adjust the Calibrats of the projector and WhiteBoard. Step 2: Power the Infrared WhiteBoard wireless module with 5V power adaptor attached. Step 3: Plug the dongle(module) into the computer's USB port. Attention: The distance between the dongle(module) and Infrared WhiteBoard must be ≤ 15M and no obstacles shielding electromagnetic wave are allowed.
Click , follow the instructions and complete the installation of the Infrared WhiteBoard software. For the most comprehensive functions, you can click , and complete the installation as the instructions show. Application Uninstallation If you are sure to delete the Infrared WhiteBoard software from your computer, click "Programs and Features" in "Control Panel". Choose " WhiteBoard " and click "Uninstall".
Search and bind the Infrared WhiteBoard If the Infrared WhiteBoard is with RF wireless connection, the computer should also search and bind the WhiteBoard after application installed.
Step 3: Searching lasts for a while until the IEEE address appears and shows the current WhiteBoard found. If nothing appears, check if the hardware connection is correct or not. Step 4: Check the IEEE address of the WhiteBoard. The Infrared WhiteBoard wireless module has a label shows its IEEE address. IEEE address Step 5: Click and choose the WhiteBoard you want to bind in drop-down menu.
represents the chosen or the current bound WhiteBoard( Bound WhiteBoard is at the top by default). Attention: Carefully check the IEEE address and must not bind other WhiteBoards or else they will be disconnected. If you can not find the correspondent IEEE address in the list, click" Search Again". If you can not find the correspondent IEEE address after many times"Search Again", check if the hardware connection is correct or not.
Exit after successfully bound and wait for 15 seconds, the drive icon in the taskbar notification area will turn green from red as follow: 8
Calibrate To work normally, the handwriting of the projected image on the WhiteBoard should coincide with the actual one so as to calibrat accurately. The following situations need Calibration.
Step 4: Vertically touch the centre of the flashing "十" with the WhiteBoard pen tip untill the flashing "十" move to the next Calibration point and thus one point is Calibrated. Follow the instructions in the Calibration interface and complete the Calibration of other points and thus the Infrared WhteBoard Calibration is finished. Notes: Wrong Calibration may lead to WhiteBoard not working or abnormal working and this requires reCalibration.
Trouble-shooting ※For the products with wireless connection, refer to this table. Solutions to Problems Problems Appearances No drive icon on the Presumable Causes Solutions Drive is not started up Start up the drive Drive is not installed Install the drive The WhiteBoard is not connected Refer to " Set wireless "and with the computer search and bind the WhiteBoard.
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.