English ѣᮽ Page 1~14 15~27
English Safety precautions Precautions described here are intended for safe and correct use of this product and are to prevent injury and damage to you and others before they occur. Precautions are classified as follows. Make sure to observe the precautions because they are all important in relation to safety. Indicates an imminently dangerous situation in which improper handling may result in death or serious injury to a user.
Do not use this product on the following regions. (Cause of an accident or trouble) - Regions where orthopedic treatment was given - Eyeballs and upper eyelids - Wound sites - Facial melanoderma - Mucosal regions, such as inside the mouth - Regions irritated due to pimples or skin rash - Regions which suffer from sensation of pain or perception disorder - Regions where metal, plastic or silicone etc.
Never wash this product with water. And, never soak in water or splash water on this product. (Cause of a failure or short circuit) Use prohibited in wet areas Disassembly prohibited Never use, charge or leave this product in places splashed with water or in damp places, such as in a bathroom. (Cause of a failure or short circuit) Never modify this product. Only a qualified technician may make repairs.
Names of parts and their functions (Fig. 1) Head (titanium material) Attach cotton and apply it to the skin. The device vibrate while it is being used. Mode indicator lamp (orange) Turn the power switch "On," and "CLEANSING" will start flashing. Then, it switches and lights up while the device is being used. Mode switch button Every time the button is pressed, the mode for use will be switched. Power switch (" ") Turn on the power switch, and it will turn "On." Press it again, and it will turn "Off.
The standard charging time is 5 hours. The device can be used approximately 10 times on a single charge. (1 time means that all modes are being used once at “High” level.) Depending on the operating conditions such as the ambient temperature, operating times may decrease. Time to charge When the power is ON, if a warning sound can be heard, it is a signal to indicate recharging. Charge as soon as possible. In order to make full use of battery performance, observe the following.
Thenot ring has an a clear direction. Attach from straight above with Do attach theorientation ring in the with reverse direction. Please be itcareful theto wider part of inner circumference placed toward the head. not squeeze it, the otherwise, it cannot be removed. 4. How to remove the ring. (Fig. 5) Remove the ring by pulling it straight up while holding down the lower part. 5. Please observe the following so as not to damage your skin when you use the device.
Daily treatment (Required time: approximate 15 minutes) Step 1 "CLEANSING" Step 2 "MOISTURIZE" Step 3 "MASK" (milky lotion) Standard daily treatment. Fine vibration in “Mask” mode and gentle switching of the electrode will enhance the moisturizing effect of lotion. Weekly treatment (Required time: approximate 15 minutes) Step 1 "CLEANSING" Step 2 "MOISTURIZE" Step 3 "MASK" (use of sheet mask) Care for the skin thoroughly once or twice a week in “Mask” mode using a commercially available sheet mask.
CAUTION Unless you apply the cotton to your skin while touching the back plate, the device will not vibrate. (skin sensing function) If the head is not vibrating, the device is not working. If you leave the device as it is for about 5 minutes without vibration, the device will automatically switch "Off." (Automatic shutoff function) Apply the cotton gently to the face and slowly move the device by sliding it from the center of the face to the outer side.
6 Apply cotton to the skin and move the device slowly. 5 Hold the device with your hand touching the back plate of the body. (Fig. 7) Make sure to hold the body with your hand touching the back plate. (Fig. 8) The mode indicator lamp will switch and turn on, and the device will start to vibrate. The time for use is within 5 minutes. CAUTION Unless you apply cotton puff to your skin while touching the back plate, the device will not vibrate.
It is recommended that when using the device for the first time or if you feel some discomfort, use the device in "Low." 4 Hold the device with your hand touching the back plate of the body. (Fig. 7) Make sure to hold the body with your hand touching the back plate. 5 Apply the head directly to the skin and move it slowly. (Fig. 8) The mode indicator lamp will switch and turn on, and the device will start to vibrate. The time for use is within 5 minutes.
It is recommended that when using the device for the first time or if you feel some discomfort, use the device in "LOW." 4 Hold the device with your hand touching the back plate of the body. (Fig. 7) Make sure to hold the body with your hand touching the back plate. 5 Apply and move the head slowly. (Fig. 8) Theusing modeaindicator lampslide will switch andover turnthe on,sheet and the device will start to vibrate. When sheet mask, the head mask. The time for use is within 5 minutes.
Care for main body Wipe off the toner/moisturizing product on the head and the body with a tissue. When dirt is difficult to remove, wipe it off with a cloth after saturating it with water and wring it thoroughly. Do not clean the main body with water. Or do not dip in water, and do not pour water. (Cause of failure) Make sure to turn OFF the switch. (Improperly turning on the switch may give a tingling sensation or result in malfunction or short-circuit.) CAUTION Do not use alcohol, benzine, or thinner.
NOTICE Attention for Use Make sure to hold the main body of the product with your hand touching back plate and apply the head of the product to your skin. Otherwise, the product will not be operated. Back plate About Skin Sensing Function This product which is operated through the human body. The electric circuit operates with skin in contact with the back plate and the head of the product. About Operating Time The continuous operating time of each mode is default.
FAQs No. Questions Answers Q1 Tingling sensation is felt on the skin. Check the intensity level. If it is set on "High" level, press the level switch button to switch to "LOW" level. If toner in the cotton pad wears off, replenish it again. If you still feel uncomfortable on the skin, stop using the product immediately and consult a dermatologist. Q2 Can "CLEANSING" mode remove makeup? This product cannot remove makeup. Please use a makeup remover cleanser.