E NGLISH ENGLISH SPLIT TYPE AIR CONDITIONER INDOOR UNIT/OUTDOOR UNIT MODEL RAS-D10CDK/RAC-D10CDK RAS-D13CDK/RAC-D13CDK OUTDOOR UNIT INDOOR UNIT RAS-D10CDK RAS-D13CDK RAC-D10CDK RAC-D13CDK Instruction manual Page 1~20 To obtain the best performance and ensure years of trouble free use, please read this instruction manual completely.
SAFETY PRECAUTION • Please read the “Safety Precaution” carefully before operating the unit to ensure correct usage of the unit. Pay special attention to signs of“ Warning” and “ Caution”. The “Warning” section contains matters which,if • not observed strictly, may cause death or serious injury. The “Caution” section contains matters which may result in serious consequences if not observed properly. Please observe all instructions strictly to ensure safety. The signs indicate the following meanings.
• The product shall be operated under the manufacturer specification and not for any other intended use. • Do not attempt to operate the unit with wet hands, this could cause fatal accident. • When operating the unit with burning equipments, regularly ventilate the room to avoid oxygen insufficiency. • Do not direct the cool air coming out from the air-conditioner panel to face household heating apparatus as this may affect the working of apparatus such as the electric kettle, oven etc.
PRODUCT PERFORMANCE AND TECHNICAL PARAMETERS • Fuzzy control • High performance rotary compressor • Low noise air intake system • Temperature sensing automatic dehumidify cation • Sleep mode with automatic adjustable temperature controls • High performance timer • Remote control swing mode • Automatic parking air vent grilles • Automatic fan speed adjustment • Left right drain hoses • Automatic functions • High sensing thermostat • minute delay circuitry • fan speed selection
INDOOR UNIT AIR FILTER To prevent dust from coming into the door unit. (Refer page 15) INDOOR UNIT INDICATORS Light indicator showing the operating condition. (Refer page 6) FRONT PANEL SUPPORT PANEL HORIZONTAL DEFLECTOR • VERTICAL DEFLECTOR (AIR OUTLET) (Refer page 13) REMOTE CONTROL Send out operation signal to the indoor unit. So as to operate the whole unit. (Refer page 7) OUTDOOR UNIT DRAIN PIPE Condensed water drain to outside.
ATTACHING AND REMOVING FRONT PANEL • While gripping both the left and right hand edges [recessed in the front housing] of the front panel, lift up to open the front panel. • After completion of job, slightly lift up the front panel and pull down to close the front panel. Ensure that the sets of left, centre and right clips are fully secured. RECEIVABLE INDICATOR FUNCTIONS Operation Lamp (YELLOW) This lamp lights during operation.
REMOTE CONTROLLER This controls the operation of the indoor unit. The range of control is about meters. If indoor lighting is controlled electronically, the range of control may be shorter. This unit can be fi xed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can be controlled from the remote controller. Transmission sign The transmission sign blinks when a signal is sent.
COOLING OPERATION Use the device for cooling when the outdoor temperature is 1- °C. If humidity is very high (over 0°C) indoors, some dew may form on the air outlet grille of the indoor unit. 1 Press the (COOL). button so that the display indicates Set the desired FAN SPEED with the (the display indicates the setting). 2 (FAN SPEED) button (AUTO) : The FAN SPEED is HI at fi rst and varies to MED or LOW automatically when the preset temperature has been reached.
Use the device for dehumidifying when the room temperature is over 1 °C. When it is under 1 °C, the dehumidifying function will not work. 11 22 STOP Press the (DEHUMIDIFY) button. The FAN SPEED is set at LOW automatically. The FAN SPEED button does not work. Set the desired room temperature with the TEMPERATURE button (the display indicates the setting). ˚C The range of 0- °C is recommended as the room temperature for dehumidifying. Press the (DEHUMIDIFY). Dehumidifying operation starts with a beep.
CIRCULATION OPERATION 1 2 3 STOP Press the button so that the display indicates (CIRCULATE). Press the FAN SPEED button and select the desired FAN SPEED (the display indicates your choice). Press the temperature control button to set to the desired temperature. Press the (CIRCULATION) button. Circulating operation starts with a beep. Press the (STOP) button to stop operation. ■ As the settings are stored in memory in the remote controller, you only have to press the (CIRCULATION) button next time.
Press the ENGLISH HOW TO SET THE SLEEP TIMER (SLEEP) button, and the display changes as shown below. Mode Sleep timer SLEEP Indication 1 hour 2 hours 3 hours Sleep timer off 7 hours Sleep Timer: The device will continue working for the designated number of hours and then turn off. Point the signal window of the remote controller toward the indoor unit, and press the SLEEP button. The timer information will be displayed on the remote controller. The TIMER lamp lights with a beep from the indoor unit.
HOW TO SET THE TIMER ■ ON Timer and OFF Timer are available. ■ Operation stop at setting time OFF Timer Reservation OFF TIME setting • • Select the OFF TIME by pressing the (OFF) Button. Setting time will change according to the below sequence when you press the button. 1 hour interval 1 2 3 9 10 11 12 ON Timer Reservation ON TIME setting • • Select the ON TIMER by pressing the (ON) Button. Setting time will change according to the below sequence.
ENGLISH AIR FLOW LOUVERS ADJUSTMENTS 1. Adjusting the left and right air flow directions Move the vertical air flow louvers as illustrated, to adjust the air flow to flow towards the left or right directions. Horizontal air deflector 2. Adjusting the downward air flow direction. During the "Dehumidifying" or "Cooling" operating modes, the horizontal air flow louvers are automatically adjusted to suit the air flow angles of each operating mode.
HOW TO EXCHANGE THE BATTERIES IN THE REMOTE CONTROLLER When using the remote control, there is no response from the air conditioner unit and or the remote control has fading and dim displays, the batteries in the remote control device need to be removed and replaced with new ones 1 Remove the cover as shown in the fi gure and take out the old batteries. = 2 Install the new batteries. The direction of the batteries should match the marks in the case. CAUTION 1.
ENGLISH THE IDEAL WAYS OF OPERATION Suitable Room Temperature Install curtain or blinds It is possible to reduce heat entering the room through windows. Warning Freezing temperature is bad for health and a waste of electric power. Effective Usage Of Timer Ventilation At night, please use the“sleep timer operation mode”, together with your wake up time in the morning. This will enable you to enjoy a comfortable room temperature. Please use the timer effectively.
FOR USER’S INFORMATION The Air Conditioner And The Heat Source In The Room Caution If the amount of heat in the room is above the cooling capability of the air conditioner (for example: more people entering the room, using heating equipments and etc.), the preset room temperature cannot be achieved. Not Operating For A Long Time When the indoor unit is not to be used for a long period of time, please pull out the power plug.
CAUTION Ensure that the unit is not in operation and all power supply has been disconnected before cleaning the units. Dust Filter Screen Dust filter screens are installed to remove the indoor dust particles hence they should be kept clean at all times. They should be cleaned at each machine operation cycle of approximately 100 hours. Excessive dust collected at the dust fi lter screen will block the air fl ow, reduce the cooling capability and could produce noise.
CLEANING THE FRONT PANEL 1. Front panel can easily get dirty. Use a soft cloth to wipe it. . If the front panel is excessively dirty, wipe the front panel with a soft cloth either wet with warm water or containing a mild detergent after which, wipe dry the front panel with a soft dry cloth. . Do not use hot water ( 0°C and above), volatile liquid, gasoline,acid, diluting agents or brushes to clean the front panel as they could damage the plastic fi nishing and paintwork of the front panel.
WHEN ASKING FOR SERVICE, CHECK THE FOLLOWING POINTS.
This product conforms with the protection requirements of council directives / /EEC relating to electromagnetic compatibility and / /EEC relating to electrical equipment designed for use within certain voltage limits. Please note: On switching on the equipment, particularly when the room light is dimmed, a slight brightness flsuctuation may occur. This is of no consequence. The conditions of the local Power Supply Companies are to be observed.
RAS-D10CDK/RAC-D10CDK RAS-D13CDK/RAC-D13CDK RAC-D10CDK RAC-D13CDK RAS-D10CDK RAS-D13CDK
11
隔塵網 吹 吹 RAS-D10CDK, RAS-D13CDK 780 280 211 RAC-D10CDK, RAC-D13CDK 792 420 299
1 2 3