INSTRUCTIONS-PARTS LIST This manual contains important warnings and information. READ AND KEEP FOR REFERENCE. 308–043 Rev. F Supersedes Rev. C and PCN D INSTRUCTIONS Displacement Pump 1000 psi (70 bar, 7 MPa) Maximum Working Pressure Model 210–208, Series F GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN COPYRIGHT 1990, GRACO INC. Graco Inc. is registered to I.S.
Table of Contents Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Setup/Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Parts Drawing and Parts List . . . . . . . . . . . . . . . . . . . . 10 Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INJECTION HAZARD Spray from the gun, leaks or ruptured components can inject fluid into your body and cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also cause serious injury. D Fluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate medical attention. D Do not point the gun/valve at anyone or at any part of the body. D Do not put your hand or fingers over the spray tip/nozzle.
FIRE AND EXPLOSION HAZARD Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and result in a fire or explosion and serious injury. D Ground the equipment and the object being sprayed. Refer to Grounding on page 5. D If there is any static sparking or you feel an electric shock while using this equipment, stop spraying immediately. Do not use the equipment until you identify and correct the problem.
Setup/Operation General Information NOTE: Reference numbers and letters in parentheses in the text refer to the callouts in the figures and the parts drawing. NOTE: Always use Genuine Graco Parts and Accessories, available from your Graco distributor. Grounding 3. Fluid hoses: use only electrically conductive fluid hoses. 4. Air compressor or hydraulic power supply: follow manufacturer’s recommendations. 5.
Service Notes D Repair Kit 223–439 is available to service the pump. For the best results, use all the kit parts. Parts included in the kit are marked with an asterisk in the text, for example (15*). D If possible, have all the necessary replacement parts available before you begin the repair, to reduce down time. D When replacing the displacement rod (36) or the cylinder (38), always replace all of the pump packings, seals, and glands, to ensure proper sealing.
Service 1 Lower Holes 4 Lips of V-packings must face down 2 Torque to 50–60 ft-lb (68–81 NSm) 5 Torque to 30–40 ft-lb (41–54 NSm) 3 Tighten in a criss-cross pattern THROAT 39 39 47 3 2 13 14 4 41 24* 45* 4 *46 *44 32 36 38 41 1 PISTON 36 28 1 18** *15 28 †16 49 43 *15 42 *31 30 *31 35 3 5 25 06644 Fig.
Service Throat Packings (Fig. 1) 1. Remove the intake valve and the cylinder (38) as explained in the previous sections. 2. Remove the packing nut/wet-cup (39). 3. Pull the displacement rod (36) out of the bottom of the outlet housing (41). 4. Remove the throat packings and glands from the outlet housing. 5. Clean all parts thoroughly, and inspect them for wear or damage. Replace parts as needed. NOTE: Always replace the male gland (44) and the bearing (47) when the throat packings are replaced. 6.
Notes
Parts 39 36 *24 †47 15 38 16† *45 49 28 *46 43 24* 32 31* 15* †18 30 44* 13 14 41 31* 42 28 35 25 32 06645
Parts Model 210–208, Series F Displacement Pump Includes items 13–49 Ref No. Part No. 13 14 15* 16† 100–127 100–128 100–579 101–178 18† 101–718 24* 25 111–334 104–272 28 30 31* 32 35 36 38 39 161–599 166–597 188–846 171–692 171–696 217–478 181–269 186–054 41 42 186–055 223–437 43 223–438 44* 45* 46* 47† 48 49 104–260 108–845 104–263 186–056 172–477 110–728 Description Packing Conversion Kit 224–443 Use to convert pump to UHMWPE and PTFE packings. Order kit separately. Includes: Qty.
The Graco Warranty and Disclaimers WARRANTY Graco warrants all equipment listed in this manual which is manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale by an authorized Graco distributor to the original purchaser for use. Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.