User Manual

Important Notices
・Quoting or partial / total reprinting of the
contents of this document without license is
prohibited.
・The contents of this document are subject to
change without notice.
・In case of any errors, inaccuracies or omissions
in the contents of this document, please notify
Hitachi, Ltd.
・Hitachi, Ltd. Permits the acquisition and use of
the product according to the conditions indicated
in this Hardware Operations Manual.
・According to the statements contained in the
previous paragraphs, Hitachi, Ltd. Will not
assume any liability for effects arising from the
use of this product. Consequently, do not use
the product unless you fully understand its
operation.
1 Introduction
Hitachi gratefully acknowledges your
implementation of the Hitachi USB Finger Vein
Biometric Authentication Unit (hereafter referred to
as “FV Unit”).
Please read all guidelines in this manual carefully
before using this product. This manual should be
kept for the future reference.
The objective of this hardware operations manual
is to provide a basic understanding of how to
handle and use the FV Unit. Information on the
use with a finger vein authentication application
software should be provided in the operations
manual of each application software.
Notes
Attention: If the unit is not properly handled,
a unit failure may occur.
Important: If the device is not properly
handled, certain function may not
respond properly.
1.1 Safety Guidance
・
Do not use this product near wet places
such as humidifiers, washing machines,
cooking plates, washbasins, baths and
the like. This may cause damages to
the product.
・
Do not use damaged or badly bent USB
cables. If the cable is damaged, this
may cause interruptions or malfunction.
・
・
・
・
Do not dismantle or modify this unit. It
may lead to damage and malfunction.
Product Reliability
・This product has been designed and
manufactured for general office use. Avoid its
use for applications that require extremely high
reliability or in cases where lives or property
may be at stake, for example, the control of
chemical plants, medical devices, urgent
communications and etc. Hitachi, Ltd. assumes
no liability for such uses and for any derived
circumstances that may lead to accidents if
used inappropriately.
・We do not guarantee the correct functioning of
this product if it is used simultaneously with
other identification devices.
Regulations and Measures
ICE-003 Statements
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
Federal Communications Commission (FCC)
Statement
Note: This equipment has been tested and found
to comply with the limits for a class B digital
devices, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. There is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
Exports Regulations
Before exporting the product, verify legal
requirements in each country in addition to U.S.
regulations for export control, and make all
necessary arrangements accordingly. The above
applies to attachments and software surrounding
the device as well. Contact Hitachi, Ltd. should
you have any concerns.
Disposal
When discarding this product, follow all regional
and local laws.Also consult regulations regarding
the material of each component.
1.2 Package Contents Verification
The package consists of the items listed below. In
case the package does not contain any of these
items, please contact to the retailer.
・FV Unit ···························································· 1 unit
・USB Cable (80cm) ·········································· 1 unit
・Hardware Operations Manual ······················ 1 copy
(This document)
2 FV Unit Outline
2.1 FV Unit Components and Functions
HitachiUSBFingerVeinBiometric
AuthenticationUnitPC‑KCS50
HardwareOperationsManual
 Attention
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:(1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
FCC WARNING
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the
equipment.
Properly attached USB cable must be used for
connection to host computers in order to meet
FCC emission limits.
Image from Top and Side
Indicator LED
Scanning area
Near infrared lights
Touch sensor
Image from Back
USB connector
Mini-B Type
Image from Front
Hall for strap
ü
ü
ü
ü
n
n
n