EN OPERATING INSTRUCTIONS DISHWASHER HUI6220XCUS
Contents Your dishwasher ........................................................................................ 2 Important safety instructions ..................................................................... 3 Before washing for the first time ............................................................... 4 Loading the dishwasher ............................................................................ 5 Using the dishwasher .......................................................................
Important safety instructions SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE NSF/ANSI 184 certified residential dishwashers are not intended for licensed food establishments. WARNING! WARNING! When using your dishwasher, follow basic precautions, including the following: • Read all instructions before using the dishwasher. • Use the dishwasher only for its intended function. • Use only detergents or wetting agents recommended for use in a dishwasher and keep them out of the reach of children.
Before washing for the first time waste. Your dealer can take the packaging for recycling or direct you to the nearest recycling center. The packaging is comprised of: • Corrugated cardboard made from up to 100% recycled material. • Expanded polystyrene (EPS) with no added chlorine or fluorine. • Supports made from untreated wood. • Protective plastic made from polyethylene (PE). Checking water hardness Contact the local water utility to check the water hardness in your area.
Loading the dishwasher Greener dishwashing • Do not rinse under running water. Simply scrape off large food particles before loading the dishwasher. • Choose an environmentally-friendly detergent. Read the environmental declaration on the packaging! • Do not start the dishwasher until it is fully loaded to save energy. • If the dishes are only lightly soiled, you can select a program with a low temperature.
Lower basket Typical load Place plates, side plates, serving dishes, pots, and cutlery (in the cutlery basket) in the lower basket. Recommended for daily, regular, or typical use. Cutlery basket Place cutlery with the handles facing down, except for knives, and spread them out as much as possible. Ensure that spoons do not stack inside each other. Place the cutlery basket in the lower basket. Cutlery basket with lid The cutlery basket lid can be removed.
Using the dishwasher Add detergent The main power switch Press to open Press and hold the main power switch until the display turns on. Also check that the water supply valve is on. PROGRAMS - Select a program Select a program to suit the type of dishes and how dirty they are. Press the desired program until the program symbol is activated. 1. Prewash detergent compartment 2. Main wash detergent compartment Detergent is added according to water hardness.
Door Open The dishwasher door opens automatically, which improves the drying results. Wait until the dishwasher indicates that the program has ended and the dishes have cooled before unloading the dishwasher. (If the dishwasher is built-in, the surrounding furnishings must be resistant to any condensation from the dishwasher.) Stopping or changing a program If you want to change the program after starting the dishwasher, open the door then press and hold the main power switch until the display turns off.
Special programs (CLn) Press and hold the associated option buttons to activate a special program. The program starts when the door is closed. Self Clean (CLn) Self-cleaning program for sanitizing the dishwasher tub, spray arms, and spray pipes. This program should be run (with no dishes in the machine) using regular dishwasher detergent or citric acid. Special dishwasher cleaners are also available in stores.
--- / 25 10 / 25 --- / 25 --- / 10 --- / --- Auto Intense Normal 3) Quick Rinse 2 2 1 70 °C 160 °F 50 °C 120 °F 35 °C 95 °F Consumption values 1) 0.8 The energy label performance figures are based on this program. This program is recommended for daily, regular, or typical use to completely wash a full load of normally soiled dishes, such as plates, serving dishes, cups and glasses. 0.01 2.6 3.49 4.5 3.7-5.3 Connection to cold water, approx. 50 °F (10 °C).
Settings Open the settings menu: Auto + Fast 1. First, open the door. Turn off the machine. Press and hold the main power switch until the display lights up. 2. Within 10 seconds: - press the program button for Auto and the option button for Fast. 3. The display shows the settings menu (current setting and its currently set value). (Exit the menu by browsing through the menu or pressing the main power switch.) Navigate the settings menu: Press to browse between setting values.
Care and maintenance instructions 2. Clean the fine filter. Top up with rinse aid When the rinse aid needs topping up, the above symbol lights on the display. Press to open 3. Refit the fine filter and turn the locking ring clockwise to its stop position. Check that the edges seal properly. Remember to refit the coarse filter! NOTE! Dishwashing results may be affected if the filters are incorrectly fitted. Note that the dishwasher must not be used without the filters in place! NOTE! 1.
Unblocking the drain pump If the dishwasher still contains water after the program has finished, something may be blocking the drain pump. Such items are easily removed. 1. Turn off the machine using the main power switch and unplug it from the power outlet. 2. Remove the coarse filter and the fine filter. 3. Scoop out the water from the dishwasher tub. The door and the door seal Regularly clean the sides of the door and the door seal. Use a slightly damp cloth (with a little cleaner if necessary).
Troubleshooting Type of fault on the display Action F10 Overfilling Clear the drain pump. See the chapter Care and maintenance instructions. If the problem persists, call the Customer Care Center. F11 Water outlet fault See “Water remains in the dishwasher above the filters” in the table “Problem” below. If the problem persists, call the Customer Care Center. F12 Water inlet fault Check that the water supply valve is on. If the problem persists, call the Customer Care Center.
Problem Possible causes The dishwasher does not start. The door is not closed properly or was Close the door within four seconds, othnot closed immediately after starting the erwise the dishwasher will not start. See program. Starting the dishwasher in the chapter Using the dishwasher. Action The door lock has not clicked into place Check the door lock. If it has not clicked and locked. into place, open the door. Press and hold the button for the Door Open option for 15 seconds. Then wait 30 seconds.
Problem Possible causes Spots on stainless steel or silver. Some types of food, such as mustard, Rinse off these types of food if not startmayonnaise, lemon, vinegar, salt, and ing the dishwasher immediately. Use the dressings, can mark stainless steel if left Rinse program. for too long. Spots or films on the dishes. Action All stainless steel can cause spots on silver if they come into contact during dishwashing. Aluminum can also cause spots on dishes.
Problem Possible causes Water remains in the dishwasher above The filters are blocked. the filters. The filters are not fitted correctly. Bad odor in dishwasher. The dishes are not dry enough. Action Clean the coarse and fine filters. Check that the filter handle is locked in the stop position. The handle should point straight out from the dishwasher. Debris in the drain pump. Clean the drain pump. See the chapter Care and maintenance instructions. Drain pump stop missing.
Installation instructions [''] Nominal dimensions. Actual measurements may vary. Important safety instructions • Connections to electricity, water, and drainage must be performed by a qualified professional. • Always follow applicable regulations for water, drainage, and electricity. • Take care during installation! Wear protective gloves! There must always be two people! • Place a drip tray on the floor beneath the dishwasher to prevent damage from any water leaks.
Placing the dishwasher The dishwasher is intended for installation under a countertop. The recess dimensions are illustrated. [''] The electrical and water supplies should enter through the area indicated by the shading on the illustration. Adjust the height and slide the dishwasher into place 1. Start by measuring the height from the floor to the bottom edge of the countertop. 2. Measure the height from the floor to the top edge of the dishwasher. 3.
min. 0.6" (14 mm) Water supply The machine can be connected to either a cold or a hot (max. 160 °F (70 °C)) water supply. The water pressure should be 4.2-140 psi. Connection to cold water supply Connect the dishwasher to the cold water supply if the building is heated using oil, electricity, or gas. Connection to hot water supply Connect the dishwasher to the hot water supply (max.
WARNING! Improper connection of the equipment grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt as to whether the appliance is properly grounded. Do not modify the plug provided with the appliance. If it does not fit the power outlet, have an appropriate power outlet installed by a qualified electrician.
Service Read the chapter Troubleshooting before contacting the service department. Provide the details on the serial number plate in all contact. Include the article number (1) and the serial number (2). ART. NO. SERIAL NO.
Notes 23
Technical information Technical data Hisense Model designation: HUI6220XCUS Height: 33.74 - 36.61'' Width: 23.80'' Depth: 22.73" Weight: 68 lb (31 kg) 1) Water pressure: 4.2–140 psi Electrical connection:See serial number plate Rated power: See serial number plate 24 Item No.: 825036. Rev. 02. We reserve the right to make changes. Weight can vary due to different specifications.