User's Manual

The user manual of TV’s WIFI module

1. Theproductdescription

The user can achieve TV connection WIFI net, through this module and the voltage supplied by the system to the

module needs to be transmitted by a voltage regulator or circuit

This equipment may be operated in all European countries.

The module installation method is as follows: pass the large round hole of the module through the limit column of

the bracket of the TV, and fix the module by the snap-fit on the bracket. Connect the external IPEX antenna to the

antenna pedestal of the module

2. Basic parameters

Feature Description Feature Description

Model MWH519B

Product Name WiFi Module

FCC ID SARMWH519B

IC ID 27123- MWH519B

Interface USB2.0

Supply Voltage 3.3V±0.2V

Dimension

30（mm）*47（mm）*6.2(mm)

Operating Temperature

-10°C to 70°C

Storage Temperature -40°C to 85°C

3. RF output power

Band Limited power

WlAN 2412MHZ-2472MHZ <20

5150MHZ-5850MHZ

4.ThedisplaymethodofModelapprovedcode

In the factory，the model approve code is pasted on the back shell in a label.

5.FCCStatement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in

accordance with the instructions may cause harmful interference to radio communications. However there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures：

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

.RadiationExposureStatement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also

PAGE 1
The user manual of TV’s WIFI module 1. The product description The user can achieve TV connection WIFI net, through this module and the voltage supplied by the system to the module needs to be transmitted by a voltage regulator or circuit This equipment may be operated in all European countries. The module installation method is as follows: pass the large round hole of the module through the limit column of the bracket of the TV, and fix the module by the snap-fit on the bracket.
PAGE 2
complies with Part 15 of FCC RF Rules. This equipment should be installed and operated with minimum distance of 20 in (50cm)between the radiator and yourbody. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter CAUTION: To comply with the limits of the Class B digital device pursuant to Part 15 of the FCC Rules, this device is compliant with Class B limits. All peripherals must be shielded and grounded.
PAGE 3
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: "Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device." Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.