WiFi Module Instruction Note: Please read this instruction thoroughly before operating the appliance -1-
WiFi Module Performance Parameters Table 1: Internal WiFi module Performance Parameters WiFi Model AEH-W4E1 Transmission frequency 2.4GHz Transmission power ≤19dBm Power supply 5V/500mA Operating temperature -20℃-80℃ Operating humidity 10%-95%RH Table 2 Standard Frequency Range Security Max. Output Power Max. Data Rate Number of Channels Modulation IEEE 802.11b/g/n 2.400-2.483.5GHz 128 bits WPA-PSK/WPA2-PSK 802.11b: 16dBm(11Mbps) 802.11g: 17dBm(54Mbps) 802.11n: 18dBm(72.2Mbps) 802.11b: 11Mbps 802.
How to install WiFi module -3-
Requirement of FCC KDB 996369 D03 for module certification: 5.1 List of applicable FCC rules and Canada rules: The module complies with FCC Part 15.247, and Canada RSS-247. 5.2 Summarize the specific operational use conditions: The module has been certified for Fix/Mobile applications. The host product operating conditions must be such that there is a minimum separation distance of 20 cm (or possibly greater than 20 cm) between the antenna radiating structures and nearby persons.
.6 Antennas: Type Gain Impedance Application PCB type 0.5 dBi Fixed 50Ω Antenna The antenna is permanently attached, can’t be replaced. Min Separation 20 cm 5.7 Label and compliance information: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
conditions suivantes : 1) L’ appareil ne doit pas produire de brouillage; 2) L’ appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptibled’ en compromettre le fonctionnement. The system integrator must place an exterior label on the outside of the final product housing the AEH-W4E1 Modules. Below is the contents that must be included on this label. OEM Labeling Requirements: NOTICE: The OEM must make sure that FCC labeling requirements are met.
-7-