User's Manual
User manual 920691A
Abt. Erz.-Bezeichnung Erz.-Nummer Blatt
PDH
1
This document is our property. Any duplication, utilization, communication or disclosure to third parties
without our prior consent is prohibited. Infringements require compensation. All rights reserved in the event
of granting a patent, registered design or design patent.
Type of Product: Amplifier for Antenna Signals for Broadcast Reception
Manufacturer: Hirschmann Car Communication GmbH
The product is mounted in a vehicle. It’s purpose is to improve the reception of
broadcast signals with a wire antennas that are integrated in the backscreen of
the vehicle.
The product is neither visible nor operable by the user of the car.
It is used and controlled by the telematic system of the vehicle.
It is also not user servicable. Therefore safety consideration is adjusted to trained
installation personnel.
DC supply is done by onboard supply through Headunit 8V power system.
Signal input comes from the reception antenna, signal output is being applied to
the signal input of a receiver.
Frequency ranges are:
Supply 8V DC vehicle on-board supply
AM: 150 … 1602kHz through headunit.
FM: 87.5 … 108MHz Gain: 6…10dB
DAB: 174 … 240MHz Size: 11x6x2cm, weight: 43gr
Working temperature: -40…85°C
Declaration of Conformity
Hereby, Hirschmann Car Communication GmbH declares that the radio equipment herein
mentioned is in compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
www.te.com/hirschmann-mobility/red
FCC
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.