User's Manual
User manual 920534D
Abt. Erz.-Bezeichnung Erz.-Nummer Blatt
PDH
1
Diese Unterlage ist unser Eigentum. Jede Vervielfältigung, Verwertung, Mitteilung bzw. Weitergabe an Dritte
ohne unsere vorherige Zustimmung ist untersagt. Zuwiderhandlungen verpflichten zu Schadenersatz. Alle
Rechte für den Fall der Patenterteilung, Gebrauchs- bzw. Geschmacksmustereintragung vorbehalten.
Type of Product: Amplifier for Antenna Signals for Broadcast and GNSS Reception
Manufacturer: Hirschmann Car Communication GmbH
The product is mounted in a vehicle. It’s purpose is to improve the reception of
radio or TV or GNSS signals with antennas that are integrated in the backscreen
of the vehicle.
The product is neither visible nor operable by the user of the car.
It is used and controlled by the telematic system oft he vehicle.
It is also not user servicable. Therefore safety consideration is adjusted to trained
installation personnel.
DC supply is done by the onboard 12V power system.
Signal input comes from the reception antenna, signal output is being applied to
the signal input of a radio tuner.
Frequency ranges are:
Supply 12V DC vehicle on-board supply
Gain: 6…10dB
Size: 11x6x2cm, weight: 43gr
DAB: 174 … 240MHz Working temperature: -40…85°C
Declaration of Conformity
Hereby, Hirschmann Car Communication GmbH declares that the radio equipment herein
mentioned is in compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
www.te.com/hirschmann-mobility/red
FCC
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.