Installation Guide

- 1 -

____Assembly Instructions____

Item No. 2355

start here---

1. Find a clear area in which you can work.

2. Unpack Fixture and glass from carton.

3. Carefully Review Instructions Prior to assembly.

*** The construction of this ﬁxture will be accomplished by ﬁrst assembling the

main body of the ﬁxture, attaching the mounting strap to the junction box,

making all necessary electrical connections, hanging the ﬁxture from the wall.

1. Remove main mounting plate (A) from ﬁxture back plate (B) by removing the 4

ﬂat head screws (C) - see Drawing 1.

2. Slide the wires from the junction box, through the large center hole, making

sure curved slots (D) line up with the threaded holes (E) in the junction box.

3. Using two 8-32 screws (F) attach the main mounting plate (A) to the junction

box, making sure the top of mounting plate (A) is parallel to ceiling.

SAFETY WARNING: READ WIRING AND GROUNDING

INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS.

TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW

WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR

LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 1 – Mounting Detail

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

PAGE 1
____Assembly Instructions____ Item No. 2355 start here--1. Find a clear area in which you can work. 2. Unpack Fixture and glass from carton. - 1 - Instructions Prior to assembly. 3. Carefully Review Drawing 1 – Mounting Detail *** The construction of this fixture will be accomplished by first assembling the main body of the fixture, attaching the mounting strap to the junction box, making all necessary electrical connections, hanging the fixture from the wall. 1.
PAGE 2
grounding instructions SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. Drawing 1 - Flush Mount supply wire A C Indoor Fixtures E 1 2 twist-on connectors D B fixture leads Drawing 2 - Chain Hung supply wire A C E twist-on connectors 1 B D E wiring instructions 2 fixture leads 1.
PAGE 3
I.S.200 Caulking Instruction____ start here--1. After securing fixture to the wall it is recommended that the gap be tween the wall and the fixture backplate be sealed with any good quality waterproof caulk or silicone sealant, on the top and sides leaving the bottom open as a weep hole. (NOT INCLUDED) see Drawing 1. Drawing 1 HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.