Instructions / Assembly

ManualsBrandsHiland ManualsOutdoor Heating45,000 BTU Black Propane Gas Commerical Patio Heater

MODEL #GS-2400-BRZ

GS-2400-BLK

GS-2650-SS

OUTDOOR

PATIO HEATER

1 WH17/01

Questions, problems, missing parts? Before returning to your retailer, call our customer

service department at 1-888-775-1330, 7 a.m. - 4 p.m., PST, Monday - Friday.

ATTACH YOUR RECEIPT HERE

Serial Number

Purchase Date

ANS Z83.26-2014 • CSA 2.37-2014 Gas-Fired Outdoor Infrared Patio Heaters

Precaution!

The Powder Coating paint process has become the

most common widely used application in the outdoor

furniture category. Unfortunately powder coating is

extremely sensitive to Humidity and Moisture. A

simple process to protect your furniture, especially

flat surfaces is to apply a simple coat of good quality

car wax prior to using. If this process is done every

few months it will protect your furniture for years

to come.

DANGER

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flame.

3. If odor continues, keep away from the appliance

and immediately call your gas supplier or fire

department.

DANGER

CARBON MONOXIDE HAZARD

This appliance can produce

carbon monoxide which has

no odor. Using it in an enclosed

space can kill you. Never use this

appliance in an enclosed space

such as a camper, tent, car or

home.

WARNING

Do not store or use gasoline or other flammable

vapors and liquids in the vicinity of this or any other

appliance. An LP-cylinder not connected for use shall

not be stored in the vicinity of this or any other

appliance.

WARNING

Improper installation, adjustment, alteration, service

or maintenance can cause property damage, injury or

death. Read the installation, operation and

maintenance instructions thoroughly before installing

or servicing this equipment.

WARNING: For Outdoor Use Only

Summary of content (19 pages)

PAGE 1
OUTDOOR PATIO HEATER MODEL #GS-2400-BRZ GS-2400-BLK GS-2650-SS DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call your gas supplier or fire department. WARNING Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.
PAGE 2
PACKAGE CONTENTS A B C D PART DESCRIPTION A Reflector Panel B Head Assembly C Cylinder Housing E F D E F G H I J G H I J 2 Door (preassembled) Post Gas Hose Regulator Bucket (preassembled) Wheel Kit Base QUANTITY 1 1 1 1 1 1 1 1 2 1
PAGE 3
HARDWARE CONTENTS (shown actual size) AA BB CC DD EE GG FF M6 Nut M8 Nut M5 x 8 mm Qty. 8 Qty. 2 Screw M6 x 10 mm M6 x 12 mm Qty. 4 Bolt Bolt Qty. 4 Qty. 8 M8 x 45mm Bolt Qty. 2 LL MM JJ KK Wing Nut Qty. 3 Wrench Stainless Qty. 1 Steel Bolt (not actual size) Qty. 4 Reinforced Ring Qty. 1 (not actual size) SAFETY INFORMATION II HH Φ6 Small Flat Φ8 Washer Washer Qty. 13 Qty. 4 NN Reflector spacer Qty. 3 Deco Ring Qty.
PAGE 4
SAFETY INFORMATION DANGER DANGER • CARBON MONOXIDE HAZARD • This heater is a combustion appliance. All combustion appliances produce carbon monoxide (CO) during the combustion process. This product is designed to produce extremely minute, non-hazardous amounts of CO if used and maintained in accordance with all warnings and instructions. Do not block air flow into or out of the heater.
PAGE 5
SAFETY INFORMATION WARNING WARNING We cannot foresee every use that may be made of our heaters. Check with your local fire safety authority if you have questions about heater use. Other standards govern the use of fuel gases and heat producing products for specific uses. Your local authorities can advise you about these. If no local codes exist, follow National Fuel Gas Code, ANS Z223.1. In Canada, installation must conform to local codes.
PAGE 6
SAFETY INFORMATION WARNING WARNING • This product is fueled by propane gas. Propane gas is invisible, odorless, and flammable. An odorant is normally added to help detect leaks and can be described as a “rotten egg” smell. The odorant can fade over time so leaking gas is not always detectable by smell alone. • Propane gas is heavier than air and leaking propane will sink to the lowest level possible.
PAGE 7
ASSEMBLY INSTRUCTIONS 1. Assemble the wheel bracket to the base with 4pcs M6X12 bolt (BB) and 4pcs M6 nut (AA). (see step 1). Assemble the other bracket in the same way. Assemble the wheel to the bracket with 1pc M8X45 bolt (DD), 1pc Φ8 Washer (HH) and M8 Nut (CC) (see step 2). Assemble the other wheel in the same way. Wheel assembly completed as shown in figure 1 step 3. Note: To improve stability, the preassembled bucket (N) can be filled with sand or water (not included).
PAGE 8
ASSEMBLY INSTRUCTIONS 4. Secure post (E) to cylinder housing (C) using the reinforced ring (MM), M6 x 10 mm bolts (FF) and Φ6 small flat washers (GG). Fasten and cover with the deco ring (NN). 4 C E Hardware Used FF NN MM M6 x 10 mm Bolt x4 GG Φ6 Small Flat Washer x4 MM Reinforced Ring x1 NN Deco Ring x1 5. Attach reflector spacers (II) and Ø8 washers(HH) to the top of head assembly (B). Tighten the reflector spacers (II). Unscrew stainless steel bolts (KK) from head assembly (B).
PAGE 9
ASSEMBLY INSTRUCTIONS 7. Slide Φ8 washers (HH) over the threaded ends of reflectors spacers(II). Attach reflector assembly to head assembly (B). Place Φ8 washers (HH) over threaded ends of reflector spacers(II) sticking out through reflector assembly and secure with wing nuts (JJ). Note: Do not overtighten. 7 HH II B Hardware Used HH Φ8 Washer JJ Wing Nut JJ x6 x3 8. Screw gas hose (F) and regulator (G) onto propane cylinder (not included). Do not cross-thread.
PAGE 10
ASSEMBLY INSTRUCTIONS A dented, rusted or damaged propane cylinder may be hazardous and should be checked by your cylinder supplier. Never use a propane cylinder with a damaged valve connection. The propane cylinder must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S. Department of Transportation (DOT) or the standard for cylinders, spheres and tubes for transportation of dangerous goods and commission, CAN/CSA-B339.
PAGE 11
OPERATION INSTRUCTIONS To check for a leak: 1. Make 2-3 oz. leak check solution (one part liquid dishwashing detergent and three parts water). 2. Apply several drops of solution where regulator connects to cylinder and to all hose and valve connections 3. Make sure all patio heater and light valves are OFF. 4. Turn cylinder valve ON. WARNING • Perform all leak tests outdoors. • Extinguish all open flames. • NEVER leak test when smoking.
PAGE 12
OPERATION INSTRUCTIONS DANGER • CARBON MONOXIDE HAZARD • For outdoor use only. Never use inside house, or other unventilated or enclosed areas. This heater consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid endangering your life. Caution: Do not attempt to operate until you have read and understand all General Safety Information in this manual and all assembly is complete and leak checks have been performed. Before Turning Gas Supply ON: 1.
PAGE 13
OPERATION INSTRUCTIONS Lighting: 1. Turn on the valve on the gas cylinder. 2. Press and turn the control knob to HIGH (maximum) position (anti-clockwise 90º). (Figure 1) 3. Holding down the control knob, press the igniter button several times until the main flame is ignited. Release the control knob 10 seconds after the ignition. 4. Turn the control knob to LOW (minimum) and leave it there for 5 minutes or more before turning the knob to the desired temperature setting. (Figure 2) 5.
PAGE 14
OPERATION INSTRUCTIONS WARNING FOR YOUR SAFETY Be careful when attempting to manually ignite this heater. Holding in the control knob for more than 10 seconds before igniting the gas will cause a ball of flame upon ignition. When Heater is ON: Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner will display tongues of blue and yellow flame.
PAGE 15
OPERATION INSTRUCTIONS Heater is away from gasoline or other flammable liquids or vapors. Heater is away from windows, air intake openings, sprinklers and other water sources. Heater is at least 24 in. on top and at least 36 in. on sides from combustible materials. Heater is on a hard and level surface. There are no signs of spider or insect nests. All burner passages are clear. All air circulation passages are clear.
PAGE 16
CARE AND MAINTENANCE Gas odor with extreme yellow tipping of flame. Heater does NOT reach the desired temperature. Heater glow is excessively uneven. Heater makes popping noises. Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles. Carbon deposits may create a fire hazard.
PAGE 17
TROUBLESHOOTING PROBLEM Burner won’t light Burner flame is low POSSIBLE CAUSE CORRECTIVE ACTION 1. Propane cylinder is frosted over 1. Wait until the propane cylinder warms up and becomes unfrosted 2. Blockage in orifice 2. Clear blockage 3. Control knob is not in ON position 3. Turn control knob to ON 1. Gas pressure is low 1. Turn cylinder valve OFF and replacecylinder 2. Outdoor temperature is less than 40ºF and tank is less than 1/4 full 3. Control knob fully ON 2. Use a full cylinder 3.
PAGE 18
ONE-YEAR LIMITED WARRANTY CUSTOMERS IN USA Do not return this product to the store where you purchased it. Please call 1-888-775-1330 for assistance. CUSTOMERS IN CANADA Only return this product to the store if it was purchased within 90 days. If you have problems after 90 days of purchase, please CALL 1-888-775-1330. DATED PROOF OF PURCHASE REQUIRED FOR WARRANTY SERVICE. This product is inspected, tested and carefully packaged to minimize the chance of damage during shipment.
PAGE 19
REPLACEMENT PARTS LIST For replacement parts, call our customer service department at 1-888-775-1330, 7 a.m. - 4 p.m., PST, Monday - Friday.