Note: The image of rear cabinet only for reference For this series, there are 10 inch, 7 inch and 6.8inch panel size. If your car's center console is large, you can install the 10.1-inch large-screen radio into the mounting hole. If your car's center console is small, you can use a hanging installation to hang the 10.1-inch large-screen radio before the car's center console. There is no need to embed it in the mounting hole. Product Size (Including screen edge): 5.6 in * 9.9 in / 14.2 cm * 25.
Wiring and Installation "ACC": Connect the car ignition detection cable "B +": Connect it to the positive terminal of the car battery. "GND": Ground / Iron / Negative battery. "KEY1/ KEY2": Only one of the cables is selected for wiring depending on the compatibility of the model and the steering wheel control system. If you use two steering wheel controllers, you need to connect 2 cables. "BACK": Connects to the rear camera input port.
If you are using your own amplifier/sub, please check its power cables wiring: If there are three power cables, "+", "-" and "REM", wiring: "+" - battery positive "-" - battery negative "REM" - car ignition switch If there are two power cables, "+" and "-" , wiring: "+" - car ignition switch "-" - battery negative Also note that the wire "ANT CONTROL" or "AMP control" don't need to connect. Thus, when your car is on, subwoofer will turn on for all audio mode, not only for radio mode.
Here's the complete steps of camera wiring. Please check step by step. 1. Camera power cable: red and black. --- Red connection to reverse the positive light, black to reverse the negative light. 2. Camera RCA cable: yellow port. ---- Insert the RCA cable of the camera on the radio rear port "CAMIN" (for Android car radio, it's a single cable with yellow port with label "rear camera/reverse/back") 3. Trigger Cable 3.