™ Portable Water Heater USER GUIDE HICPSBT
Thank you for purchasing the Hike Crew™ Portable Water Heater. This User Guide is intended to provide you with guidelines to ensure that operation of this product is safe and does not pose risk to the user. Any use that does not conform to the guidelines described in this User Guide may void the limited warranty. Please read all directions before using the product and retain this guide for reference. This product is intended for domestic use only. It is not intended for commercial use.
• Make sure all packaging is disposed of responsibly prior to first using the device. • This device is designed for outdoor use only. • Always handle the device with care and pick it up only using the built-in handle. Do not attempt to lift the device from the propane tank. • Do not use any type of adapter or attempt to modify this device to fit other connectors or cylinder types. • Children should always be supervised by an adult when around this device.
Safe Use Locations This device should only be operated in an above-ground, open-air situation where there is natural ventilation, no stagnant areas, and where gas leakage and/or products of combustion will be promptly diffused by wind. Any enclosure in which you are using this device should comply with one of the following types of safe use locations. Do not use this device in any area that does not comply with any of the following safe use locations.
PRODUCT OVERVIEW Faucet mount Front Front carry handle Control panel Water outlet Back Rear carry handle Gas regulator Power input Pump power input Pump fuse Water inlet Control panel Battery charge level Burner indicator Water inlet temperature Water outlet temperature Power on/off Start button Gas temperature control 5
CONNECTION POINTS AND ATTACHMENTS connection point #1 (Gas inlet) connection point #4 (Main DC power input) connection point #2 (Water inlet) connection point #5 (Pump DC power input) connection point #3 (Water outlet) attachment #4 (AC/DC adapter) attachment #1 (Gas regulator) attachment #2 (Pump hose) & attachment #2.
OPERATIONAL MODES This unit can operate in three different modes. Battery mode - runs the unit on battery power without any additional power supply. To run in battery mode, be sure to first charge the battery. Charging mode - runs the unit via the AC/DC power adapter (attachment #4). While operating in charging mode, the battery will charge while the unit is in use. Direct power mode - runs the unit via the 12 V DC power adapter (attachment #5).
6. Lower the filter end of the pump until it is fully submerged in a suitable water reservoir. Note: Do not use water directly from rivers, lakes, or the ocean. Do not, under any circumstance, use saltwater with this appliance. 7. Connect the shower head attachment (attachment #3) to the water outlet (connection point #3). 8. Slide shower head flow switch to the “on” position. USING THE SHOWER 1. Power on the unit. 2. Check the Battery Charge Level to see if sufficient power is available.
5. Adjust the temperature by turning the gas control until the desired level is reached. 6. The water flow can be stopped by sliding the Flow Switch to the “off” position. The burner will turn off and the pump will continue to operate. 7. Press the Power Button to turn off the device. Note: Water remaining in the heat exchanger while the flow is stopped may become very hot. When the flow is resumed, check the temperature output to make sure it is safe to use.
STORING YOUR PORTABLE WATER HEATER 1. Press the Power Button to ensure the device is switched off. 2. Disconnect all hoses and hold them vertically to allow all excess water to drain from them. Check that the flow regulator switch on the shower head is in the “on” position. 3. Unscrew the regulator assembly from the device and remove the propane tank. 4. Tip the appliance towards the back to drain excess water from the heat exchanged through the water inlet. 5.
Do not use AC to DC converters or modify the supplied adaptors. If the appliance is not being regularly used, recharge the device every three (3) months to guarantee battery life. Failure to do so may result in battery failure. Expected charging time: 25% - 1 hour 50% - 2 hours 100% - 4-5 hours To keep battery in the best condition, it is recommended to allow the device to charge to 100%. TROUBLESHOOTING Issues Solutions Water is not flowing through the shower head.
ERROR CODES Error Code Code Meaning E1 • Flame not extinguishing – turn off unit and remove propane tank. E3 • Flame/burner not lit. E4 • Water outlet issue – contact customer service. E6 • Over temperature shut off. E7 • Outlet water temperature is above 125 °F (50 °C). E8 • Tilt switch activated – place on level surface and re-start appliance. TECHNICAL SPECIFICATIONS Dimensions (H x L x W): 11.8” x 9.65” x 12.2” (30 x 24.5 x 31 cm) Weight: 13.2 lbs.
WARRANTY INFORMATION LIMITED WARRANTY TO ORIGINAL CONSUMER This Hike Crew® Portable Water Heater (“Product”), including any accessories included in the original packaging, as supplied and distributed new by an authorized retailer is warranted by C&A Marketing, Inc.
WARRANTIES AND CONDITIONS, WHETHER EXPRESSED, IMPLIED, OR STATUTORY, INCLUDING THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, TITLE, QUIET ENJOYMENT, ACCURACY, AND NON-INFRINGEMENT OF THIRD-PARTY RIGHTS. THE COMPANY DOES NOT GUARANTEE ANY SPECIFIC RESULTS FROM THE USE OF THE PRODUCT, OR THAT THE COMPANY WILL CONTINUE TO OFFER OR MAKE AVAILABLE THE PRODUCT FOR ANY PARTICULAR LENGTH OF TIME. THE COMPANY FURTHER DISCLAIMS ALL WARRANTIES AFTER THE EXPRESS WARRANTY PERIOD STATED ABOVE.