User Manual High-Flying Electronics Technology Co., Ltd. Specification Model :HF-Z100C Design Verify Approve Hewei 2014-03-12 Description : ZigBee Module Wanghuanming 2014-03-12 Document No.: F20140312 Version : 1.
User Manual 1 .Photo 2 Product Description HF-Z100C HF-Z100C is a wireless communication device based on the latest IEEE802.15.4 standard and Zigbee wireless communication protocol. When compared with the Bluetooth technology, it comes with the advantages of low complexity, low power, low cost, self-organizing, and so on. Since it is based on IEEE802.15.
User Manual 3. Product Features: Low power consumption in low-power standby mode, the standby time is more than 10 times the Bluetooth communication devices Low cost, by dramatically simplifying the protocol (less than Bluetooth 1/10), reducing the requirement for communication controller, suitable for large-scale construction applications Variable data rates, HF-Z100C works in the 2.
User Manual 4.Product Specification Model HF-Z100C Chipset 88MZ100 Wireless Standard IEEE802.15.4 Radio Data Rate 250Kbps Channel 16 Sensitivity @250kbps (dBm) -104dBm(Min) Frequency Range 2.405~2.480GHz Interface Refer to Section 5 Antenna Type Onboard 2dBi(Max)PCB antenna Input Voltage(V) DVDD 2.0V-3.6V(Typical DC 3.
User Manual 5. Interface Pin Definition The module pin reference definition is referred to the table like below. The GPIO assignment is ONLY reference for the full application on lighting. For some specified application, please refer to the PINMUX of 88MZ100 datasheet for the flexible GPIO assignment.
User Manual 6. FCC Statement: Federal Communication Commission Interference Statement FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with part 15 of the FCC Rules.
User Manual IC warning statements: -English Warning Statement: “This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device." -French Warning Statement: “Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.