Stericharger Instruction manual
Product information This product is a portable, easy to operate hand-held disinfection.The sterilization rate is 99.9%. The product has no radiation and is well cared for Your health. Principle of sterilization Apply to object surface disinfection, such as cabinet, hotel bed sheet, bath Objects such as vats, baby carriages and sofas.
Instructions 1. Use 5v-2a adapter to fully charge the product. 2.Press and hold the power key for 3 seconds, and the power key light turns blue For normal opening. 3. Press and hold the general mode button for 3 seconds, and the general mode button The lamp turns blue, and after 5 seconds of beeping, the ultraviolet disinfection lamp lights up,Enter disinfection state. 4.
the gravity mode button for 1 second,Gravity mode button light turns blue, beep 5 seconds later, purple The external line disinfection lamp lights up, enters the disinfection state, after 59 seconds ultraviolet Line disinfection light is off, gravity mode key light is off, back off Out of the disinfection state; in the disinfection state, press the 1 second gravity mode Key, gravity mode button light off, ultraviolet disinfection The lamp is off and out of the disinfection state. 6.
the ultraviolet disinfection lamp goes out, red In the disinfection state, press the infrared mode button for 1 second, and the infrared mode key light will turn off, and the ultraviolet disinfection lamp will turn off, and exit the disinfection statusState. 7. Press the Bluetooth key for 1 second, and the Bluetooth key light turns blue,Turn on Bluetooth mode and connect the product with related app After that, relevant operations can be carried out on the mobile phone Security protection mode 1.
the product will automatically exit thedisinfection state after turning over 2. Infrared induction mode: press button, infrared induction mode work When the human body is close to it, it will automatically exit the disinfection state. Voice description When the first mock exam is open and closed, the product will be "buzzing".There is a beep Technical parameter 1.Product Name: Portable disinfectant 2. Product model: Stericharer UVC 3.
4. Product size: 144 x 94 x 22.25 mm 5. Body weight: 200g 6. Input power: 5V --- 2A 7. Charging protocol: support apple, Samsung and bc1.2 interface specification 8. Power supply interface: Micro USB 9. Battery capacity: 5000mAh 10. Filling time: less than 3 hours 11. Bluetooth: ble 5.0 12. UV lamp use time: about 150 minutes 13. Standby power consumption: less than 1mA 14. Working current: less than 2.5A 15 UV wavelength: 275-285nm 16.
input under voltage, overcharge, over-current discharge protection; battery charging NTC protection. 17 Battery parameters: Battery standard voltage: 3.7V Battery charging limit voltage: 4.2V Nominal capacity of battery: 5000mAh Battery energy: 9wh Battery executive standard: GB / t18287-2013 18. Number of LED beads: 10 19. Service life of UV lamp beads: 10000 hours 20.
Packing list 1. Fuselage x1 2. USB line x1 3. Instruction manual x1 4. Hand held handle x1 Reminder 1. Please use the adapter that meets the voltage for charging, otherwise it may be damaged Bad products 2. Please fully charge the product before use. 3. Keep away from magnet when using. 4. Please keep the product manual carefully 5.
Production For any changes, please refer to the goods in the packing box.
FCC Warningprotection. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
-Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Table of harmful substances and contents in products This form is prepared according to SJ / t11364 O: It means that the content of the harmful substance in all homogeneous materials of the component is in accordance with GB / T 26572 The limit requirements are as follows X: It means that the content of the harmful
substance in at least one homogeneous part of the component exceeds the provisions of GB / t26572 Limit requirement Note: the reason why this product is marked with "X" is that there is no alternative technology or component available at this stage
Product Warranty Warranty details Thank you for purchasing our products, in order to let you rest assured that the use of this product, better To protect your rights and interests, our company will abide by the joint information production of AQSIQ On the basis of industry department, after-sales service is implemented. Not within the scope of services 1. Has exceeded the limited service or free maintenance period 2.
maintain and keep in accordance with proper instructions The consumer takes apart the product by himself. 3. It is considered that the product is defective due to factors (such as operation error, bump, improper input Voltage) Product model: . Purchase date: . Distributor: . User name: . Contact number: . User address: . This certificate is an important basis for product after-sales service.