www.tuv.com Report No.
Thermo Sensor (TS15C) USER MANUAL 1
REMOTE SENSOR FEATURES • Double-tool design • Remote temperature transmission to the main unit via 433 MHz frequency • Case can be wall mounted using built-in hanger • • Selection of the temperature display in Celsius or Fahrenheit Three channel selection • LCD displays temperature, and channel E A C D F B A. LED INDICATOR • Flashes once when the remote sensor transmits a reading to the main unit. • Flashes twice when battery power is low. B.
requirements). • • ALWAYS install batteries in the remote sensor before the main unit. Insert batteries before first use, matching the polarity in the battery compartment • • Press RESET after each battery change with a paper clip or similar tool. Remove protective plastic screen from LCD display (if any). • • During an initial setup, place the main unit close to the remote sensor.
SPECIFICATIONS Remote Sensor Remote Temperature Proposed operating range with alkaline batteries: -20°C to + 70°C (-4°F to + 158°F) Temperature resolution: 0.1°C/0.2°F RF Transmission Frequency: 433 MHz RF range: 30 meters Temperature transmission cycle: approximately 45 seconds Low battery indicator Wall-mount of Table stand Power Remote Sensor: 2 AAA size 1.5V batteries (not included) Dimensions Remote sensor: 2.35(L) x 3.77(H) x 0.
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modification to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
EC-Declaration of conformity This product contains the approved transmitter and complies with the essential requirements of Article 3 of the R&TTE 1999/5/EC Directive, if used for its intended use and that the following standard(s) has/have been applied: Efficient use of radio frequency spectrum (Article 3.2 of the R&TTE Directive) Applied standard(s) EN 300 220-2 V2.1.1:2006 Electromagnetic compatibility (Article 3.1.b of the R&TTE Directive) Applied standard(s) EN 301 489-3 V1.4.1:2002 EN 301 489-1 V1.