(Hos For Press kW) Weather Forecast with Cable Free in-out Sensor and Radio Controlled Projection Clock USER'S MANUAL ( PCR325W) INTRODUCTION . Congratulations on your purchase of the PCR325W. The basic package comes with a main unit, which is the weather forecast station and, three remote units, the therm sensor, The main unit is capable of keeping track of the maximum and minimum temperature of different sites. And no wire installation is required and operates at 433MHz.
N LIGHT SENSOR BUTTON When plug-in adapter, and the button is at position * “Auto” : the light sensor function is activated and the LED back light will turn on automatically when it is dark. * “ON”: the LED} back light will turn on whatever the environment is. * “OFF” : light sensor function is off.
BATTERY INSTALLATION: MAIN UNIT 1. Open the battery compartment door. 2. Install 2 batteries (UM-3 or “AA” size 1.5V) strictly ‘according to the polarities shown. 3. Replace the battery compartment door. | LOW BATTERY WARNING When it is time to replace batteries, the respective low-battery indicator will show up on the indoor or outdoor temperature. GETTING STARTED Once batteries are in place for the remote unit, they will start transmitting temperature readings at around 45 seconds intervals.
PROJECTION IMAGE OF CURRENT TIME AND OUT-DOOR TEMPERATURE: 12:38 2. Press "FLIP" ey 10 rotate projection image 180° clockwise. 4953 8k: 3. Press and hold the "F: the "FLIP" key for 2 seconds to change temperature information from outdoor temperature to indoor temperature, 4. Press and hold the “FLIP” key for 2 seconds again, the temperature image will swap indoor/ outdoor for every § seconds automatically.
* We recommend keeping the minimum distance of 8 feet from any interference source such as a TV, computer monitors, microwave ovens, etc. * Within concrete rooms (basements, superstructure, office buildings), the received signal will be weakened. In extreme case, the unit should be placed close to a window and/or point it’s front or back towards the Fort Collins, Colorado transmitter. * During the night time, the atmospheric disturbances are usually less severe and reception is possible in host cases.
DISCONNECTED SIGNALS If without obvious reasons the display of the outdoor temperature goes blank, Hold _ for 2 seconds to enforce an immediate search. If that fails, check: 1. The remote unit is still in place. 2. The batteries of both the remote unit and main unit. Replace as necessary. Note: When the temperature falls below freezing point, the batteries of outdoor units will freeze, lowering their voltage supply and the effective range. 3.
Press and hold MORE, OB for 3 seconds: the year, month, date, hour & minute digit will begin to flash, press “+ * to select the correct figure. After the minute is set, press MODE again, the weekday display will indicate the current preset language, “EN” for English. Press “4+” or 10 set the desired language for the weekday display. The selection sequence is “BN” for English, “SP” for Spanish and “FR” for French. . When the language is set, press MODE again, ““F> will flash to prompt Fahrenheit display.
* Pr-Alarm The per-alarm sound will be activated and the icon will be flashed if outdoor temperature under or equal zero degree, which is programmable minutes earlier than the weekday alarm or single alarm time. PRECAUTIONS } This product is engineered to give you years of satisfactory service if you handle it carefully. Here are a few precautions: 1. Do not immerse the unit in water. 2.
Power Main unit : use 2 pes UM-3 or AA” 1.5V battery Remote sensing unit : use 2 pes UM-3 or “AA” 1.5V battery Weight Main unit : 305g (without battery) Remote sensing unit : 60g (without battery) Dimension Main unit: 161(L) x T16(H) x 31D) mm Remote sensing unit : x 101(H) x 24(D) mm This device complies with Part 15 of the FCC Rules.