9292 Jeronimo Road Irvine, CA 92618-1905 HID® FlexSmart™ 607X Series Readers INSTALLATION GUIDE © 2007 HID Global Corporation. All rights reserved. February 5, 2006 Document Number 6075-900 Document Version B.
6075-900, B.2 – FlexSmart™ 607X Series Installation Guide Contents 1 Overview ............................................................................................................................................... 3 2 Mounting ............................................................................................................................................... 4 3 Wiring ....................................................................................................................
FlexSmart™ 607X Series Installation Guide – 6075-900, B.2 1 1.1 Overview Introduction The HID® FlexSmart™ readers can easily be configured at the site because the readers’ bezel can be interchangeably snapped onto the common reader module (only standard reader). The FlexSmart readers mount on any North American standard electrical gang box or on any flat surface, with snap-on bezels. 1.2 Parts Included First, unpack the contents and become familiar with the components.
6075-900, B.2 – FlexSmart™ 607X Series Installation Guide 1.4 Identifying the Reader Format The reader format is found on the ID label (see below), which is located on the reader electronics module. Reader Format 2 Mounting Figure 1 Reader Dimensions and Mounting Page 4 of 8 February 5, 2007 © 2007 HID Global Corporation. All rights reserved.
FlexSmart™ 607X Series Installation Guide – 6075-900, B.2 Figure 2 Keypad Reader Dimensions and Mounting 2.1 Mullion Mounting The following describes how the readers mount to a mullion. 1. Drill two holes 6-32 or M-3 sheet metal or thread forming screws 3.3” (8.38 cm) apart. 2. Locate and drill a 0.375” (0.95 cm) hole for the reader cable. 3. Route the cable through the center hole to the controller. 4. Using the two 6-32 or M-3 screws, attach the reader to the first two mounting holes. 5.
075-900, B.2 – FlexSmart™ 607X Series Installation Guide The following are recommended cable types and maximum cable lengths for a cable connecting the power supply to the reader. Cable Type Maximum Cable Length 24 AWG (0.60mm), three conductors, with an overall foil shield, 9533 or equivalent. 200’ (61 m) 22 AWG (0.80mm), two conductors, with an overall foil shield, Alpha 5192 or equivalent. 300’ (91 m) 18 AWG (1.20mm), two conductors, with an overall foil shield, 5836 or equivalent.
FlexSmart™ 607X Series Installation Guide – 6075-900, B.2 Notes: • Keypad outputs only available • The system must have a single earth ground point. • As shown, do not connect shield (screen) wire at reader cable splice. • For open collector (non-terminated output), consult your system manufacturer for correct cable length and type. Regulatory FCC This device complies with part 15 of the FCC rules.
6075-900, B.2 – FlexSmart™ 607X Series Installation Guide Contact Americas HID Corporation (California, USA) Email: tech@hidcorp.com main: (949) 598-1600 support: 1-800-237-7769 fax: (949) 598-1690 Europe, Middle East and Africa HID Corporation, Ltd. (Haverhill, UK) email: eusupport@hidcorp.com main: +44 (0) 1440 714 850 support: +44 (0) 1440 711 822 fax number: +44 (0) 1440 714 840 Asia-Pacific HID Asia Pacific Ltd. (Hong Kong) email: asiasupport@hidcorp.