Hi-G-Tek SPDS WIRELESS ADAPTOR User Manual UM4801 Date: 26-Nov-13 Rev: 1.
1. Introduction The following instructions describe and illustrate the principle steps involved in installation of RFID tags operating as SPDS bottom valve wireless adaptor and SPDS vapor pressure valve wireless adaptor. The SPDS tag is portable, reusable electronic device designed to monitors the access point through sensors and generate status information and alarms corresponding to various programmed conditions.
The device must not be used within non-conductive flowing media. To the externals (Sensor-1, Sensor-2, Sensor-3 and Common) only passive components, according to the user manual of the manufacturer, must be connected. Switches and resistors must meet the simple apparatus requirements according to EN 60079-11. Resistors must meet the current-limiting resistors requirements according to EN60079-11.
. SPDS bottom valve wireless adaptor Product Part No. IGSBV40xxx 4.1. General Adaptor shape is similar to the Data-Seal enclosure with the required modifications for cable connection. RF channels specifications are identical to the Data-Seal. 4.2. I/O’s The adaptor has 3 inputs and internal reed switch. The internal reed switch is used to sense removing of the enclosure from installation fixture. A magnet should be installed in the fixture. See figure 1 and 2 for reed switch location.
4.4. Input specifications: Input type: Dry contact. Polarity: Internally pulled HIGH, Activated when pulled LOW. Protections: ESD.
5. SPDS vapor pressure valve wireless adaptor Product Part No. IGSPV40xxx 5.1. General Adaptor shape is similar to the DataSeal enclosure with the required modifications for cable connection. RF channels specifications are identical to the DataSeal. The adaptor controls the relay of the pneumatic system and reads the status of the air pressure. 5.2. I/O’s The adaptor has one input, one output and internal reed switch.
6. Technical specifications. Power requirements Power Source 3.6V internal Lithium battery Life Expectancy 4 years at 50 readings per day Communication channels: Low frequency 125 kHz Low-frequency range Up to 40cm High frequency High-frequency range Model:IGSxV40433 433.92MHz Model:IGSxV40916 916.
7. ATEX Marking 0539 9 II 1 G Ex ia IIB T4 II – Equipment Group II: Surface (no-mining) equipment. 2 - Equipment Category 1: Very high degree of protection for use in Zone 0.
SPDS wireless adaptor- User Manual Page 9
SPDS wireless adaptor- User Manual Page 10
SPDS wireless adaptor- User Manual Page 11
