User's Manual

Table Of Contents

Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology

DataSeal-125 Installation

step 1.

Fig. 1

Fig. 3

To install the DataSeal-125 Mounting Fixture, attach

the fixture to the keeper bar at the back of the

container (fig.1). A

click indicates that

the

fixture is in place.

Fig. 2

To install the DataSeal-125, hold the unit at a 45

angle as illustrated and snap it into place in its

cradle on the DataSeal Mounting Fixture. (fig. 3)

step 2.

DataSeal Installation

The two side slots may be used to secure the

mounting fixture to the container, using

a 3-5mm width by 180-250 mm length

plastic strap (fig 2).

PAGE 1
DataSeal-125 Installation DataSeal Installation step 1. To install the DataSeal-125 Mounting Fixture, attach the fixture to the keeper bar at the back of the container (fig.1). A click indicates that the fixture is in place. Fig. 1 The two side slots may be used to secure the mounting fixture to the container, using a 3-5mm width by 180-250 mm length plastic strap (fig 2). Fig. 2 step 2.
PAGE 2
DataSeal-125 Installation step 3. To connect the DataSeal Wire, simply attach one end of the seal wire conectors to either of the sockets at the base of the DataSeal (fig 4). Fig. 4 Loop the wire through the container locking ring and the keeper bar, then insert the end into the other socket (fig. 5). Fig. 5 Alternatively, you may loop the wire through both keeper bars then insert the end into the other socket (fig. 6). Fig. 6 Hi-G-Tek Ltd.
PAGE 3
DataSeal-125 Installation FCC ID: OB6-IGSA125 This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.