Hi-G-Tek I.S Micro-Reader User Manual UM47xx Date: 12, Oct. 2007 Rev: 1.
1. Introduction The Hi-G-Tek I.S Micro Reader is a component of Hi-G-Tek’s wireless monitoring system designed to withstand hazardous locations such as fuel-atmosphere interactions and other harsh outdoor applications.
2. Safety Precautions The only maintenance required, is to replace the battery when necessary. To replace the battery, open the battery compartment using medium size screwdriver Take out the old battery and put a new one (Note polarity) NOTE: Use 3V Lithium type CR2032 battery only. Close properly cover after installing the fresh bat ATTENTION • Hi-G-Tek's IS Micro Reader is distributed to a commercial/industrial use only, and should only be handled by personnel authorized by Hi-G-Tek representatives.
3. Using the Micro Reader The Micro Reader performs two basic functions (depending on the application): 1) It verifies the lock/seal/tag status and provides the user with an indication as to whether the device has been tampered with since being set. 2) It can also reset the lock/seal/tag for a new use. It also leaves a “footprint” in the lock/seal/tag memory with the Micro Reader’s ID, identifying the specific Micro Reader that performed a command or interrogation. 3.
3.2 SET Command • Approach the Data Seal / Tag as to a distance of 3-8cm and press the S button. o In the event that the seal / Tag is properly secured, Green LED will turn on and a corresponding “beep” will sound indicating the SET command has been succeeded. NOTE: In the event that the SET command failed, the Micro Reader will pause for two seconds and the Red LED will turn on with a corresponding beep sound, make sure that the seal /tag is properly closed and locked.
4. Technical spec.