Programming Unit IG-IU-125PU -User Manual- UM4728 Rev. 2.
1. Introduction The Programming Unit is a desktop device that is used to configure the sensors prior to distribution or installation. The Programming Unit communicates with the sensors via the low frequency channel (125 KHz). It is externally powered and has RS232 channel to communicate with a PC. The Programming Unit is supplied with configuration software, which allows reading or writing parameters to the electronic sensor. 2.
. Installation Instructions 3.1 Connect DB9 male connector to Programming Unit side. 3.2 Connect DB9 female connector (with power cable) to PC side (COM port). 3.3 Plug in the AC/DC power adapter into the wall power outlet. 3.4 Place the electronic seal / tag up to 10cm from the Programming Unit. 3.5 Use provided Low Frequency communication software to communicate with the electronic seal / tag.