User's Manual

Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology Pg.1
DataTag – Application On Object
User Instructions.
The DataTag is delivered with a set
of double-sided tapes that are used
for placing the DataTag on the
tagged object.
The Sensor Plate (item #1) is supplied
separately from the DataTag.
To place the Sensor Plate peel the paper
from the double-sided tape (item #2) and
place the Sensor Plate in its place.
1 2
Press the sensor Tape to create the contact
between the tape and the sensor Plate.
Make sure the contacts at the bottom part
of the plate are aligned with the pins.
Peel the paper from the three pieces of
double-sided tape: The two larger pieces
(Items #3 & #4) are used for holding the
DataTag to the tagged object while the
smaller piece in the middle (Item #5) is
used for pulling the Sensor Plate off the
DataTag in order to create the TAMPER
event when the DataTag is removed from
the tagged object.
3 5 4