User's Manual

ManualsBrandsHHC Changzhou ManualsElectronicsControl Box

1/4



CH18HandControlInstructions

1.ProductOverview

ProductName：HandControl

ProductModelNo.：CH18

FCCID:2AEQWCH18HHC003



2.Environmentrequirement

Operationtemperature:+10℃~+40℃.

Storagetemperature: －10℃~65℃.

OperatingHumidity：10%~80%RH，non‐condensing.

StorageHumidity：10%~85%RH，non‐condensing.



3.DirectionsforOperation

Inordertooperate,placethree

1.5VAAAbatteriesintheremotecontrolanduseinconjunction

withtheCB18controlbox.Inaddition,thePSK2920Apowersupplyswitchmustbeconnectedas

thepowersupplyforthecontrolbox.Detailedoperationdirectionsbelow:

MatchCode：

Pressandholdthebutton,approx.15seconds,untiltheremote’sfrontindicatorlights

up.Then,connectittothecontrolboxPowerplug.Afterthebeepsound,thepairingiscomplete

andremotecanoperate.



Indicator

light



Summary of content (4 pages)

PAGE 1
CH18 Hand Control Instructions 1. Product Overview Product Name： Hand Control Product Model No.： CH18 FCC ID: 2AEQWCH18HHC003 2. Environment requirement Operation temperature: +10℃~ +40℃. Storage temperature: －10℃~65℃. Operating Humidity：10%~80%RH，non‐condensing. Storage Humidity：10%~ 85%RH，non‐condensing. 3. Directions for Operation In order to operate, place three 1.5V AAA batteries in the remote control and use in conjunction with the CB18 control box.
PAGE 2
4. The port is introduced All motorized functions of the bed are controlled by the remote control. 4.1.BackrestLift. Press this button to lift up the backrest. Keep the button pressed and release when the desired tilt is achieved. Press this button to lower the backrest. Keep the button pressed and release when the desired tilt is achieved. 4.2.FootrestLift. Press this button to lift up the footrest. Keep the button pressed and release when the desired tilt is achieved.
PAGE 3
Press this button to reduce the intensity of the back massage. Press this button to stop the back massage. Press this button to increase the intensity of the foot massage. Press this button to reduce the intensity of the foot massage. Press this button to stop the foot massage. 4.5.Backlit illumination of remote control To illuminate the buttons for better night view when press this button . The light will turn off automatically after approximately 10 seconds.
PAGE 4
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 6.3 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance.