User's Manual

ManualsBrandsHHC Changzhou ManualsElectronicsControl Box

1/3



CB18ControlBoxInstructions

1.ProductOverview

ProductName：ControlBox

ProductModelNo.：CB18

FCCID:2AEQWCB18HHC004



2.Environmentrequirement

Operationtemperature:+10℃~+40℃.

Storagetemperature: －10℃~65℃.

OperatingHumidity：10%~80%RH，non‐condensing.

StorageHumidity：10%~85%RH，non‐condensing.



3.DirectionsforOperation

Tousethecontrolbox,

thePSK2920Aswitchpowersupplymustbeconnectedasthecontrol

boxpower supply.TheCH18remotecontrol must also be paired to be used.Detailedusage for

eachportisasfollows:

Beforeuse,theCH18remotecontrolandCB18controlboxmustbepaired:

Pressandholdthebutton,approx.15seconds,untiltheremote’sfrontindicatorlights

up.Then,connectittothecontrolboxPowerplug.Afterthebeepsound,thepairingiscomplete

andremotecanoperate.

Indicator

light



Summary of content (3 pages)

PAGE 1
CB18 Control Box Instructions 1. Product Overview Product Name： Control Box Product Model No.： CB18 FCC ID: 2AEQWCB18HHC004 2. Environment requirement Operation temperature: +10℃~ +40℃. Storage temperature: －10℃~65℃. Operating Humidity：10%~80%RH，non‐condensing. Storage Humidity：10%~ 85%RH，non‐condensing. 3. Directions for Operation To use the control box, the PSK2920A switch power supply must be connected as the control box power supply. The CH18 remote control must also be paired to be used.
PAGE 2
LED Connection SYNC Cord Connection Head Motor Port USB Connection Power Input connection Head Massage Motor Port Foot Massage Motor Port Foot Motor Port Tilt Motor Port 4. The port is introduced 4.1 “HD Motor”：Connects to the Head motor, and lifts/lowers head section. 4.2 “FT Motor”：Connects to the Foot motor, and lifts/lowers foot section. 4.3 “Tilt Motor”：Connects to the Tilt motor, and adjusts tilt. 4.4 “Power”：Connects to the power supply box, controls power supply. 4.
PAGE 3
on/off. 5. Matters needing attention： 5.1 The function will only work normally in proper working power conditions. 5.2 Control box input voltage must be less than 29.2VDC. 5.3 The CH18 remote control is needed for proper control. 5.4 If problems are identified, they must be treated by professional personnel. 6. Additional attention for user： 6.1 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.