User's Manual

1/3



CB11ControlBoxInstructions

1.ProductOverview

ProductName：ControlBox

ProductModelNo.：CB11

FCCID:2AEQWCB11HHC002



2.Environmentrequirement

Operationtemperature:+10℃~+40℃.

Storagetemperature: －10℃~65℃.

OperatingHumidity：10%~80%RH，non‐condensing.

StorageHumidity：10%~85%RH，non‐condensing.



3.DirectionsforOperation

Tousethecontrolbox,the

PSK2920Aswitchpowersupplymustbeconnectedasthecontrolbox

powersupply.TheCH11remotecontrolmustalsobepairedtobeused.Detailedusageforeach

portisasfollows:

3.1Beforeuse,theCH11remotecontrolandCB11controlboxmustbepaired:



3.2Then, turn on the con tr ol box's Power, and after the beep sound the system will work.

Followtheexamplebelowtoproperlyplugpartsin.



PAGE 1
CB11 Control Box Instructions 1. Product Overview Product Name： Control Box Product Model No.： CB11 FCC ID: 2AEQWCB11HHC002 2. Environment requirement Operation temperature: +10℃~ +40℃. Storage temperature: －10℃~65℃. Operating Humidity：10%~80%RH，non‐condensing. Storage Humidity：10%~ 85%RH，non‐condensing. 3. Directions for Operation To use the control box, the PSK2920A switch power supply must be connected as the control box power supply. The CH11 remote control must also be paired to be used.
PAGE 2
SYNC Cord Connection Head Motor Port LED Connection USB Connection Power Input connection Foot Motor Port 4. The port is introduced 4.1 “HD Motor”：Connects to the Head motor, and lifts/lowers head section. 4.2 “FT Motor”：Connects to the Foot motor, and lifts/lowers foot section. 4.3 “Power”：Connects to the power supply box, controls power supply. 4.4 “USB”：Connects to the USB adapter box, and USB adapter box and USB socket connection. 4.5 “LED”：Connects with lights.。 4.6. “SYN”：Same steps.
PAGE 3
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.