Installation Instructions

2A3SYMBL01 is a low-power embedded Wi-Fi module developed by Dongguan

Techway Technology Co., Ltd. It consists of a

It is composed of a highly integrated radio frequency chip BL2028N and a small

number of peripheral devices, with a built-in Wi-Fi network protocol stack and

Rich library functions.

2A3SYMBL01 Can support AP and STA dual-role connection, and support

Bluetooth low energy connection at the same time. A 32-bit MCU with a maximum

operating speed of 120 MHz, built-in 2Mbyte flash memory and 256 KB RAM, and 3

channels of 32-bit PWM output is very suitable for high-quality smart home

control.

Model: WiFi Module

Model: 2A3SYMBL01

Input Voltage: 3V~3.6V

Power: 210mA

Product Picture as below

End Product Labeling

MBL01 has been labeled with its own FCC ID. The end product manufacturer must

ensure that FCC labeling requirements are met. If the FCC ID of 2A3SYMBL01 is not

visible when the module is installed inside another device, then the device must have

a clearly visible label containing the following information:

Contains FCC ID: 2A3SYMBL01

PAGE 1
2A3SYMBL01 is a low-power embedded Wi-Fi module developed by Dongguan Techway Technology Co., Ltd. It consists of a It is composed of a highly integrated radio frequency chip BL2028N and a small number of peripheral devices, with a built-in Wi-Fi network protocol stack and Rich library functions. 2A3SYMBL01 Can support AP and STA dual-role connection, and support Bluetooth low energy connection at the same time.
PAGE 2
Note 1: This module certified that complies with RF exposure requirement under mobile or fixed condition, this module is to be installed only in mobile or fixed applications. A separate approval is required for all other operating configurations, including portable configurations with respect to Part 2.1093 and difference antenna configurations. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 3
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.