Installation Instructions

ManualsBrandsHES ManualsElectronicsElectric Strike Slim-Line in Satin Stainless Finish

HES 9400/9500/9600

Electric Strike

Installation Instructions and Frame Preparation

Product Components

A 9400/9500/9600 Strike Body

B 9400/9500/9600 Cover

C 1/4"-20 x 1" Mounting Screws

D #10-32 & 10-24 Lockdown Screws (optional)

E #6-32 x 1/4" Cover Screws

F 5/64" Hex Key

G 12-Volt and 24-Volt Pigtails

Electrical Specifications

Electrical Ratings for Solenoid

Continuous Duty 12 VDC 24 VDC

Resistance in Ohms 24 96

Amps .50 .25

Solenoids are rated at +/- 10% indicated value.

Minimum Wire Gauge

Requirements

(Based on Round Trip)

Solenoid Voltage

12 VDC 24 VDC

200 feet or less 18 gauge 22 gauge

200 – 300 feet 16 gauge 22 gauge

300 – 400 feet 16 gauge 20 gauge

Diagram 1: Product Components

Summary of content (4 pages)

PAGE 1
HES 9400/9500/9600 Electric Strike Installation Instructions and Frame Preparation Product Components Diagram 1: Product Components A 9400/9500/9600 Strike Body A B 9400/9500/9600 Cover B C 1/4"-20 x 1" Mounting Screws D #10-32 & 10-24 Lockdown Screws (optional) E #6-32 x 1/4" Cover Screws F 5/64" Hex Key G 12-Volt and 24-Volt Pigtails Electrical Specifications Electrical Ratings for Solenoid Continuous Duty 12 VDC 24 VDC Resistance in Ohms 24 96 Amps .50 .
PAGE 2
Installation CAUTION Before connecting any device at the installation site, verify input voltage using a multimeter. Many power supplies and low voltage transformers operate at higher levels than listed. Any input voltage exceeding 10% of the solenoid rating may cause severe damage to the unit and will void the warranty. Preparing the Strike NOTE: For 12 VDC, the Plug In Connector (pigtail) marked “12 VDC” should be used; for 24 VDC, the pigtail marked “24 VDC should be used.
PAGE 3
Finishing the Installation 1 Electrically CONNECT the 9400/9500/9600 to the Plug In Connector, and ATTACH the electric strike to the jamb using the 1/4"-20 x 1" mounting screws provided.
PAGE 4
Frame Preparation Adjusting Horizontal and Lockdown Template 1 LOOSEN the two 1/4"-20 x 1" mounting screws. NOTE: May not be to scale. For easy installation, the template should be ordered. 2 ADJUST strike to appropriate horizontal position 1-3/4" [44.5mm] 3 TIGHTEN the two 1/4"-20 x 1" mounting screws Set Screw Location Mounting Screw Lockdown Screw (optional) 1/2" [12.7mm] Clearance for LBM/LBSM Wiring 4-1/8" [104.8mm] 1-1/16" [27mm] 1-5/16" [33.3mm] Set Screw Location 1-5/16" [33.