Product Manual A

BED LINER KIT
TM
TM
HERCULINER Brush-on Bed Liner is a polyurethane-based product that is designed to be easily applied to any truck bed with great results.
It is important that you follow the application instructions as closely as possible. Any deviation or deletion from these application
instructions may have a negative effect on the end results. Be sure to read all instructions and warnings completely before beginning. If you
have any questions regarding these procedures or safety issues about HERCULINER, please call our customer service line at
[phone] between the hours of 8AM and 5PM CST.
Important: This kit contains one (1) gallon of HERCULINER, which is sufficient to cover one (1) six-foot truck bed. Eight-foot truck beds will
require an additional quart of HERCULINER.
INSTRUCTIONS:
(1) Remove tailgate.
(2) Clean heavy dirt and
grime from truck bed and tailgate. Sweep out large debris and use a household detergent such as
TSP (Trisodium Phosphate) and
water to thoroughly remove all dirt, including oil spots and petroleum products residue.
Make sure to rinse surface
well with a clean rag and fresh water. Allow truck bed and tailgate to dry thoroughly.
(3) Remove tailgate hardware if it is in an area that you are going to coat.
(4) Mask off all areas that you wish not to be coated.
(5) At the same time fill drain plugs and latch bolt holes with masking tape
.
(6) Using the scouring pad provided, scuff all paint surfaces where
HERCULINER is to be applied, leaving no glossy areas.
(7) Blow out or wipe down truck bed and tailgate, removing all
excess sanding dust.
Carefully masking areas where you do not want HERCULINER applied is one
of the most important aspects of application. Be sure to take your time and
rub masking tape down for a good protective seal. Remember, the cleaner
your mask job, the better the outcome.
Sweep out the truck bed
thoroughly of any large debris.
Other items you will need
to complete the job:
• One quart of Xylene (Xylol),
Acetone or MEK Solution
for surface preparation only
• 2" wide masking tape
• Paint roller pan
• Rubber gloves
• Clean up rags
• Stir stick or paint mixing
drill attachment
CAUTION: HERCULINER bonds to skin, clothing and metal surfaces
quickly and is very difficult to remove once it dries. Be careful
to avoid getting any residue on your skin, painted surfaces and
clothing. Use Xylene (Xylol) or Acetone immediately to remove
HERCULINER, and wash area with soap and water. See
PRECAUTIONS AND
WARNING LABELS for further information.
Be sure to scuff all painted surfaces
where HERCULINER is going to be
applied, leaving no glossy areas.
This will provide a superior bond
between HERCULINER and the
truck bed surface.
BED LINER APPLICATION INSTRUCTIONS
Old World Industries, Inc., 4065 Commercial Ave., Northbrook IL 60062 [phone] FAX [phone] www.herculiner.com
WARRANTY: OLD WORLD INDUSTRIES, Inc. warranties this product against faulty manufacture and defective materials. OLD WORLD INDUSTRIES, Inc. will not accept product liability for application or use of this product.
2/02
CAUTION: BEFORE YOU START! It is very important that this product be applied in a well ventilated area
and that chemical resistant gloves are worn during application.