Instructions / Assembly

a) Using one of the two split jambs (green
end up, red end down) and stiffeners
insert 3 ribs into stiffener channel at
screw holes. Align and fasten using one
screw, per hole. See detail b.
b) Repeat using
remaining split jamb
and stiffener, insert
final 3 ribs into
stiffener.
3
ii
5
4
a
detail b
b
Install steel floor saddle at bottom of pocket
at low end of ribs (as pictured) positioned
approximately three inches from split jambs.
Install header plate at top of pocket frame
making sure that split end jambs and
stiffeners are together and insert into center
of header plate. Pocket frame is complete
and ready for installation.
Note: The door track faces down with the
backbone at the track end.
6995 Central Ave
Newark, CA 94560
[phone]
Henry
Pocket Frames
NOTE: Make sure inside ribs are 2 inches apart
NOTE: Make split jamb ends are even at the ribs
www.henrypocketframes.com
Henry Pocket Frames
Made in the USA