Installation Instructions

Table Of Contents

Only for CK series Bluetooth Keyboard

1. Go to "Setting" in the Windows and select "Bluetooth and other device", select "add Bluetooth or other

devices"

2. In the prompt out window, select "Bluetooth

3. Pressing "Fn + ESC" to switch the keyboard Into Bluetooth pairing mode, indicator LED will flash.

4. On the PC side, in the prompt out window, the PC should be able to find a device called "CKxxx". please

select the "CKXXX".

5. A window will prompt out for showing a pairing code, please type exactly the provided code on the

keyboard as shown in the window and then press the "Enter on the keyboard to confirm the pairing.

6. After the Step 5, indicator LED will stop flashing. the keyboard should be able to show up in the "Mouse,

keyboard, & pen" category, now the keyboard is connected to the target PC and ready to use.

Charging the Keyboard

Connect the keyboard to a USB2.0 port rated at 500mA, the keyboard will start charging immediately, 5

hours recommended for fully charging the Keyboard.

PAGE 1
Only for CK series Bluetooth Keyboard 1. Go to "Setting" in the Windows and select "Bluetooth and other device", select "add Bluetooth or other devices" 2. In the prompt out window, select "Bluetooth 3. Pressing "Fn + ESC" to switch the keyboard Into Bluetooth pairing mode, indicator LED will flash. 4. On the PC side, in the prompt out window, the PC should be able to find a device called "CKxxx". please select the "CKXXX". 5.
PAGE 2
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.