User's Manual

User Manual

Technical Specification

 USB interface

 Input currency: < 200mA

 Storage temperature: -40°~+60°

 Ambient temperature: +25°

 Humindity:20%~90%

Installation and operation

- Install the driver contained in the attached CD-ROM

- Plug the USB-A connector into the USB port of PC and it can work momentarily.

- For RFID card, set the serial port as follow: Baud Rate: 9600, Data Bit: 8, Stop Bit:1, Verify

and Flow control: None.

- For smart card reader, run “SC sample.exe” program and the following window will be shown.

Then insert proper smart card into the card slot and we may get the information by the program

accordingly

PAGE 1
User Manual Technical Specification USB interface Input currency: < 200mA Storage temperature: -40°~+60° Ambient temperature: +25° Humindity:20%~90% Installation and operation - Install the driver contained in the attached CD-ROM Plug the USB-A connector into the USB port of PC and it can work momentarily. For RFID card, set the serial port as follow: Baud Rate: 9600, Data Bit: 8, Stop Bit:1, Verify and Flow control: None. For smart card reader, run “SC sample.
PAGE 2
Appendix Changes or Modifications not expressly approved by the party responsible could void the user’s authority to operate this device. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.