RT602 M C RT 602
PIC 01 1.Antenna 19.Lamp 18.Lock 17.Vox 16.Scanning 15.Channel/Menu item 2.Battery Level 3.CTCSS / Menu option SCAN 4.TX/RX Icon TX RX 14.PTT Button 5.Volume 6. Lamp Button 13.Power Button 7.Up Button M C 8.Down Button 12.MENU/Keypad Lock Button 9.Call/Scan Button 11.Microphone 10.
PIC 02 23 20 21 2
E N~ I nstr ucti o ns for u se This set includes 2 walkie-talkie units: these are communication devices which operate on mobile radio frequencies. They come with 22 channels as well as a back-lit LCD screen, enabling you to communicate over several kilometres free-of-charge. N OT E : Please read these user instructions carefully before using the equipment and retain for future consultation! SPECIFIC RECOMMENDATIONS ● If you carry any kind of personal medical device, consult a doctor before use.
ITEM DESCRIPTION (Pic 01,02) 1. 2. 3. 4. Antenna Battery level indicator CTCSS / Menu option -value RX icon -Displayed when receiving TX icon -Displayed when transmitting 5. Volume level indicator 6. Lamp Button 7. Adjustor button Up (▲ ) 8. Adjustor button Down (▼) 9. Call/SCAN button(C) 10. Loud speaker 11. Microphone 12. M: Enter the menu settings 13. On /off button( ) 14. Push to talk (PTT)button 15. Channel/Menu item indication 16. Scanning indication: Displayed during scan mode 17.
BE F O RE U S E ( P i c 0 2 ) To insert batteries into the devices, first remove the belt attachment: lift the attachment clip (20) and press the belt attachment upwards. Release the Battery compartment cover latch (21) located on the rear side of the unit. Open the battery compartment (23) and insert 3 AAA batteries or NI-MH rechargeable batteries (22)(not supplied), ensuring that the poles are correctly aligned. Then close the lid. U S I N G T H E T W I N TAL K E R 1.
4. Receiving/transmitting communications: The devices are in 'Reception' mode when lit up, i.e. they are ready to receive a call or sound transmitted on the activated frequency. ● When you press the Call tone button (9), the device switches to 'Transmission' mode. There will be sound signal from the walkie talkies. ● To send a voice message, press the PTT button (14) and speak into the microphone (11). Continue to press PTT the button until you finish talking.
6.CTCSS (Continious Tone Coded Squelch System) License free radio's operating on the 462.5625~467.7250 Mhz frequency band, like the kids walkie talkie , have 22 available channels channels. If there are many walkie talkie users in your neighborhood, there is a chance that some of these users are operating on the same channel. To prevent that you receive unknown signals from other users, sub-channels will be needed.
8. VOX Selection The walkie talkie has VOX function. In VOX mode, the walkie talkie will transmit a signal when it is activated by your voice or other sound around you without pressing PTT button. VOX operation is not recommended if you plan to use your walkie talkie in a noisy or windy environment. Note: VOX mode will be overrided when you press the PTT - button “ 14 ”. ● Press the MENU- button(12) three times, the current VOX setting flashes on the display and the VOX icon is displayed.
. Call Tones A call tone alerts others that you want to start talking. 1. Setting the Call Tone The Walkie talkie has 10 different call tones. ● Press the MENU- button(12) four times, “CA” is displayed and the current call tone is flashing. ● Press the ▲-button(7) or the ▼-button(8) to change to another Call Tone. ● Press the PTT - button(14) to confirm and return to stand-by Mode. 2. Sending a call Tone Press the CALL-button(9) briefly. The call tone will be transmitted on the set channel. 11.
To set the Roger Beep. ● Press the MENU- button(12) six times. “rO” will be displayed. ● Press ▲ to enable (ON) or ▼ disable the Roger Beep (OF). ● Press the PTT - button(14) to confirm your selection and return to the standby mode. 13.Button Lock ● Press and hold the MENU- button(12) for three seconds to activate the Button lock mode. The button lock icon (a key near the battery indicator) will be displayed on the LCD Screen.
16.BUILT-IN FLASH LIGHT As an added feature,your walkie talkie has a built-in flashlight that can be used in sending light signals or for your lighting needs with a button on the right side of the device. 17 Charge The PMR(PIC 02) In the event you wish to use the unit with rechargeable battery. You will be requited to use an DC adaptor. ● Install 3.6V “AAA” NI-MH rechargeable battery Pack into the unit. ● Place the unit into the Charger Base.
EU Channel Frequency Channel Frequency Channel Frequency 1 446.00625 5 446.05625 2 3 446.01875 446.03125 6 7 446.06875 446.08125 4 446.04375 8 446.09375 USA Channel Frequency Channel Frequency Channel Frequency Channel Frequency Channel Frequency Channel Frequency Channel Frequency 1 2 3 4 462.5625 462.5875 462.6125 462.6375 5 6 7 8 462.6625 462.6875 462.7125 467.5625 9 10 11 12 467.5875 467.6125 467.6375 467.6625 13 14 15 16 467.6875 467.7125 462.5500 462.
FCC NOTICE AND DECLARATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation Any modification to a walkie-talkie to receive transmissions from Service frequency bands voids the certification of the scanning receiver, regardless of the date of manufacture of the original unit.