OPTION FULL PROTECTION USER GUIDE / SDU FORK SENSOR Helite www.helite.com helite@helite.
User Guide 3 y It is possible to pair as many vests as you like with one fork sensor. y Rider and pillion rider can use the same fork sensor. To check if your vest has recognized the fork sensor, you just need to place the magnet on the fork sensor. A short beep on the vest indicates that it is recognizing the sensor and that the fork sensor and the vest are connected. B.
User Guide 4 a) Place the sensor on the bottom of one of the fork sleeves of the motorcycle. Please check that no part of the motorcycle comes into contact with the sensor while riding. b) Add the shim if necessary to adjust the fork sensor. c) Tighten the screw by using the nut. Do not tighten more than 1.5 Nm to avoid breaking the fork sensor (you can stop screwing when it gets difficult to turn the bracelet with your hand). C.
User Guide Caution: The vest sensor is sensitive to sudden body movements. Do not intentionally execute movements that are not necessary for normal motorcycle riding. It is equally important to not intentionally cause shocks to the fork sensor when your vest is on. Both of these cases could trigger and consequently inflate the airbag. 4. Autonomy Once installed and correctly paired (see first use, page 10), the fork sensor is totally autonomous (about 5 years).
User Guide 6 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
User Guide 6. Warranty & After sales service A. EXCHANGE If you encounter any of the problems described below, please contact a dealer or contact us for repair or exchange of the product: - the activated (switched on) vest does not show any reaction when you place the magnet over the sensor. - the SDU fork sensor flashes red when you place the magnet over the round sign during the first 5 years of purchase. After sales service: Contact us via mail: sav@helite.com or via telephone: +33(0) 3 80 35 48 26 B.
@HeliteOfficial helite@helite.com N° SDUM0720201 www.helite.