FML22-R2 ASSEMBLY INSTRUCTION MODEL:FML22-R2 • Please read these instructions carefully before using. • This model will hold most 26”-42” Flat Panel TVs. • Load capacity: (33Lbs). Please read this 15kg instruction carefully before assembly. Fits for 26-42in plasma and LCD TV.
Safety Warning: Never let children climb on product or play with product. Do not sit or stand on product. Do not fasten a TV that is heavier than the recommended load rating to the mount installation may cause property damage • Improper Please read these instructions carefully before starting.and/or personal injury, s installation must be done by two qualified contractors. The manufacture is not liab • damage This product will caused hold most Panel TVs.
Safety Warning Please read this entire manual carefully before assembling this unit to avoid bodily injury and/or any property loss. If you do not understand these directions, or have any doubts about the safety of the installation, please call Tech Support at 1-866-839-9187. Please check carefully to ensure there are no missing or defective parts. Our customer representatives can quickly assist you with installation questions and missing or defective parts.
Step 1:Pls remove the plaster board on the surface of concrete wall when assemb mount on the concrete wall.Hold wall plate (A) against wall at desired position on concrete wall, then usingtheaplaster pencilboard mark hole locations . Then drill holes according remove on3the surface of concrete wall when assembling Step 1:Pls Assembly Instructions pencil mount marksonusing 2/5" or 10mmwall size drill to a wall depth of 2.5"/64mm the concrete wall.Hold plate (A)bit against at desired position on.
tep 3:Hang pre-assembled TV unit on the wall plate and fix them using screws F . Step 3: H ang pre-assembled TV unit on the wall plate and fix them using screws (F) Step 3:Hang pre-assembled TV unit on the wall plate and fix them using screws F . F P F P Figure 4 Figure 4 tep 4:Fix TV completely avoid any moving if you are driving the car. Step 4: F ix TV completely to avoid any moving if you are in motion. Step 4:Fix TV completely avoid any moving if you are driving the car.
Step 5: You may need to rotate the handle to adjust the TV to your desired viewing angle. Step 5:You may need rotate the handle to adjust TV to your desired angle. + - Handle ±5° Figure 6 Note: Pay extra care and attention when you fasten TV mounts to EXTRA AND ATTENTION TV MOUNTSmount thePAY back panelCARE of the TV in Step 3.WHEN MakeYOU sureFASTEN the appropriate TO THE is BACK PANEL OFproperly. TV IN STEP 2 . MAKE SURE THE APPROPRIATE hardware being used IS BEING USED PROPERLY . 1.
Notes: ______________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ _______________________
©2016 Metra Electronics Corporation, 460 Walker Street, Holly Hill, FL 32117-2699 Specifications are subject to change without notice. All trademarks are the property of their respective owners. 1-866-839-9187 • www.metrahometheater.