Operation Instructions

The following is the operational instruction for your IP-Link 1000.

1) Install the IP_Link on your board.

2) Using your installation CD, install the Helicomm IP-Software inot you computer.

3) Apply power to your module.

4) Via your interface cable connect the IP-Link 1000 to the computer.

5) Down load the firmware into your module.

"This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation."