User's Manual

Operation Instructions
The following is the operational instruction for your IP-Link.
1) Using your installation CD, install the Helicomm IP-Software.
2) Take the top cover off the IP_Link unit.
3) Install a CR2477 battery. This is a 3 volt button battery.
4) Connect the parallel port from your PC to that of the interface board.
5) Connect the RS232 cable from the interface board to the IP-Link.
6) Using your flash programmer software, download the latest software into the IP-
Link unit.
7) The two LED’s should flash on and off.
"This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation."