User Manual Product Name: EM3587 ZigBee Module Model Name: DSM-001
1. Product introduction 1.1 Summary DSM-001 ZigBee wireless module, based on silicon labs EM358x series chip, has high performance, low power consumption, works in ISM band, fully supports IEEE802.15.4 standard, supports ZigBee-PRO protocol Stack. 1.2 Performance characteristics Complete System-on-Chip -32-bit ARM® Cortex -M3 processor -2.4 GHz IEEE 802.15.
2 Hardware Description 2.1 Pin Description The pins of the DSM-001 series module are shown below. No Name of Pin 1 GND 2 GND 3 3.3V 4 Type Direction Description GND Power GND GND Power GND VCC Power Supply Voltage 3.3V 3.3V VCC Power Supply Voltage 3.
8 NC / / / 9 PWM1 10 PB0 CMOS I/O General IO port 11 I2C_SDA CMOS I/O Two Wire serial Interface- data port 12 I2C_SCL CMOS I/O Two Wire serial Interface- clock port 13 PA0 CMOS I/O General IO port 14 PA3 CMOS I/O General IO port 15 NC / / / 16 NC / / / 17 NC / / / 18 NC / / / 19 NC / / / / / / PWM1 NC 20 21 PB5 CMOS I/O General IO port 22 PB6 CMOS I/O General IO port 23 PB7 CMOS I/O General IO port 24 NC / / / 25 PC1 CMOS I/
3. Specifications 3.1 Electrical characteristics limit parameters Modules must be within the conditions described below and may cause damage beyond the range described in the table below. Parameter Supply voltage All pins Stored temperature Min. -0.3V -0.3V -40ºC Max. 3.6V VDD+0.3V 150ºC Min. 2.0V -40ºC Max. 3.6V 85ºC 3.2 Working conditions Parameter Working voltage Environmental temperature 3.3 Working current Test conditions VDD=3.0V @ +25°C Operating mode Min. Max.
Center frequency offset ±40ppm RF output impedance 50Ω including temperature range and aging 4 Welding Reflow soldering is recommended to operate according to the temperature curve shown below. 160 Temperature 25～160℃ Target time(s) 90～130 5. Certification FCC 190℃ 30～60 Pk. Temp ～ >220℃ 220℃～Pk.
OEM Guidance 1. Applicable FCC rules This module is granted by Single Modular Approval. It complies to the requirements of FCC part 15C, section 15.247 rules. 2. The specific operational use conditions This module can be used in IoT devices. The input voltage to the module is nominally 3.3V DC. The operational ambient temperature of the module is -40 to 85 degree C. Only the embedded PCB antenna is allowed. Any other external antenna is prohibited. 3. Limited module procedures Not Limited module 4.
6. Antenna Antenna type: PCB antenna; Peak gain: 0 dBi 7. Label and compliance information An exterior label on OEM’s end product can use wording such as the following: “Contains Transmitter Module FCC ID: 2AV5NMSWUP-310” or “Contains FCC ID: 2AV5NMSWUP-310.” 8.
. Additional testing, Part 15 Sub part B disclaimer The final host / module combination need to be evaluated against the FCC Part 15B criteria for unintentional radiators in order to be properly authorized for operation as a Part 15 digital device.
