User's Manual

User manual
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1)this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS OR CHANGE TO
THIS EQUIPMENT. SUCH MODIFICATIONS OR CHANGE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
INSTRUCTIONS FOR RADIO CONTROL OPERATOR SINGLE ENTRY TRANSMITTER
MODEL NO.:X220-3
Read the following instructions thoroughly before using transmitter.
1.Remove the transmitter cover
Remove the access cover from the front of the transmitter by sliding the cover away from the
top of the transmitter(Figure A).this will expose the battery . In order to facilitate the replacement
of the battery.
2.The transmitter is rolling code encoding and transmitting, it will automatically and receiver
code matching.
FIGURE A
FIGURE B
Button batteries
If the receiver successfully decoded, the receiver will normally work.
User can click the push button,A signal tramsit out.