User's Manual

MODEL NO.: U220S5-1
Read the following instructions thoroughly before using transmitter.
User manual
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:(1)this device may not cause harmful interference,and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Match the transmitter to receiver
- Press and hold a button on transmitter for transmission.
-Then press the Learn button on your receiver.The adjacent indicator light will
flash.Release the button of transmitter.The receiver will now operate when you
press the button of transmitter.
Detail for add/remove a transmitter,please check with the instruction of your
receiver.
NOTE:If the red light on the transmitter is dim or flickers when the transmitter
button is pushed,the transmitter battery may be weak. Replace when
necessary with a CR2032 3 Volt battery.
WARNING:The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment.Such modifications could
void the user’s authority to operate the equipment.
Figure A
Slide the cover for battery
replacement .
CR2032
Battery Type
CR2032
Figure C
Figure B
HEDDOLF
HEDDOLF
HEDDOLF
INSTRUCTIONS FOR RADIO CONTROL TRANSMITTEROPERATOR SINGLE BUTTON ENTRY
Remove the access cover from the front of the transmitter by sliding the cover
for battery replacement (Figure C).
Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

Summary of content (6 pages)