User's Manual

MODEL NO.: U219S5-1
Read the following instructions thoroughly before using transmitter
User manual
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:(1)this device may not cause harmful interference,and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Program the transmitter setting to receiver
-Press and hold a button on transmitter for transmission.
-Then press the Learn button on your receiver.The adjacent indicator light will
flash.Release the button of transmitter.The receiver will now operate when you
press the button of transmitter.
Detail for add/remove a transmitter,please check with the instruction of your
receiver.
WARNING:The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment.Such modifications could
void the user’s authority to operate the equipment.
Battery Type CR2032
INSTRUCTIONS FOR RADIO CONTROL TRANSMITTEROPERATOR SINGLE BUTTON ENTRY
Figure A
NOTE:If the red light on the transmitter is dim or flickers when the transmitter
button is pushed,the transmitter battery may be weak. Replace when
necessary with a CR2032 3 Volt battery.
-Unscrew the screws(Figure A).
-Remove the front cover from the transmitter(Figure B).
Open transmitter for battery replacement
Battery replacement
Front cover
Screws
Figure B
Figure C
-Battery replacement (Figure C).
LED
Button
Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.