User's Manual

User manual
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1)this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH
MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.
INSTRUCTIONS FOR RADIO CONTROL OPERATOR SINGLE ENTRY TRANSMITTER
MODEL NO.:P219-1
Read the following instructions thoroughly before using transmitter.
This transmitter must be adjusted so that the coding switches match the coding switches on
your present operating transmitter or receiver.
1.Remove the transmitter cover
a Unscrew the screws(Figure A).
b Remove the front cover from the transmitter(Figure B).
2.Setting the code
You may set your transmitter to any code you desire,but be sure the code you set matches on
both your transmitter and receiver.
there are 9bit dip switches on your transmitter,each of which can be placed in three different posit
-ions(+,0,-). Do not set all switches in same position,such as all +,or all - (Figure C).
WARNING:No other adjustments should be made inside the transmitter.
Now that you have selected your personal code,replace the transmitter cover.
FIGURE A
1 2 3 4 5 6 7 8
ON
FIGURE B
Dip switch
Button batteries
User can click the push button. A signal tramsit out. If the inside
dip switch match the receiver switch, receiver will work.
9
＋
０
－
FIGURE C
Heddolf Products Limited
Remote Controller