User's Manual

User manual
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1)this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
TTHE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS OR CHANGE TO
THIS EQUIPMENT. SUCH MODIFICATIONS OR CHANGE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
INSTRUCTIONS FOR RADIO CONTROL OPERATOR SINGLE ENTRY TRANSMITTER
MODEL NO.:M220 Series
Read the following instructions thoroughly before using transmitter.
This transmitter must be adjusted so that the coding switches match the coding switches on
your present operating transmitter or receiver.
1.Remove the transmitter cover
Remove the access cover from the front of the transmitter by sliding the cover away from the
top of the transmitter(Figure A).this will expose the battery and the dip switches. the code can
be changed using a small screwdriver.
2.Setting the code
You may set your transmitter to any code you desire,but be sure the code you set matches on
both your transmitter and receiver.
there are 8bit dip switches on your transmitter,each of which can be placed in two different posit
-ions(ON,OFF). Do not set all switches in same position,such as all ON,or all OFF(Figure B).
WARNING:No other adjustments should be made inside the transmitter.
Now that you have selected your personal code,replace the transmitter cover.
FIGURE A
1 2 3 4 5 6 7 8
ON
FIGURE B
Dip switch
Button batteries
User can click the push button. A signal tramsit out. If the inside
dip switch match the receiver switch, receiver will work.
9 10