Installation Instructions

HEBEI HUACHUANGDA TECHNOLOGY CO.LTD

HCD-1235L1CON CONTROLLER INSTRUCTION

The electronic board is used for kid car, and controls kid car to move forward,move back, swing. Also,can adjust speed accordingly.

Power by battery to drive motor, turn via motor too.

1 use right adapter to recharge the battery, keep the value 12 voltage output.And keep away from children when recharging.

2 Pay attention to the color wire to connect, take care of positive pole and negative pole. Bus line,jumpers connected correctly.

3 Do not dip into water, in case of short circuit.

4 Do not expose the board under rainy and sun.

5 Press the button power firstly,the car is stand by. Press Rock button, the kid car swing from time to time, until the button is

switched to run.

6 Under the run status,step on the pedal to accelerate,loose to decrease speed. At the same time, pull the rocking bar to forward

or back.

7 From the acousto-optic wire, the board can receive blue tooth signal in 2.4G frequency, and operate the kid car to move. That

means, the remote control box can undertake, and cell phone can undertake via APP too.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

PAGE 1
HEBEI HUACHUANGDA TECHNOLOGY CO.LTD HCD-1235L1CON CONTROLLER INSTRUCTION The electronic board is used for kid car, and controls kid car to move forward,move back, swing. Also,can adjust speed accordingly. Power by battery to drive motor, turn via motor too. 1 use right adapter to recharge the battery, keep the value 12 voltage output.And keep away from children when recharging. 2 Pay attention to the color wire to connect, take care of positive pole and negative pole. Bus line,jumpers connected correctly.
PAGE 2
Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.