we art oN SIMPLIFY RE technologies Electric Fireplace Model: sf E-35 BUILDER BOX INSTALLER/CONSUMER SAFETY INFORMATION PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING APPLIANCE. WARNING! IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, AN ELECTRICAL SHOCK OR FIRE MAY RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. FOR YOUR SAFETY SERVICE MUST BE PERFORMED BY A QUALIFIED SERVICE AGENCY.
Congratulations! Congratulations on selecting a Oversimplify electric fireplace. ‘The unit you have selected is designed to provide the utmost in safety, reliability and efficiency. As the owner of a new fireplace, you'll want to read and carefully follow all of the instructions contained in this owner's manual. Pay special attention to all cautions and warnings. This owner's manual should be retained for future reference.
A\ WARNING Fire Risk + Do not install or operate damaged heater, « Do not modify heater. «+ Installation other than as instructed by Hearth & Home Technologies inc. is strictly prohibited. + Do not operate the heater without fully assembling all components. » Installation and/or use of any component part not approved by Hearth & Home Technologies. Hearth & Home Technologies disclaims any responsibility for, and the warranty and agency listing will be voided by the above actions. A\ WARNING Improper installa
UNPACKING THE UNIT WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a qualified service technician to inspect and replace any parts of the electrical system if necessary. Carefully remove packaging from the unit The front screen is held in place with ‘Clips To remove the screen grasp it firmly and pull owt. The logs and grate are held with tie-wraps to shipping stops. The tie-wraps and shipping stops must be removed prior to using the appliance.
FIREPLACE DIMENSIONS Rough ‘Concerning Depth Mt 12% (13mm) Rough Opening Widen L Rough Opening or Eighty Rush Nailing Flagella Fig. 4 Fireplace Specifications and framing dimensions.
SERVICE INSTRUCTIONS WARNING: Disconnect power at circuit breaker before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury. REPLACING THE LIGHT BULB This fireplace uses a single 12 Volt, 36 Watt; MR-18 bulb. The bulb is located behind the smoke shield, A spare is provided with unit. Replacement bulbs (Part available through your Simplify re dealer. 1. Turn off power to the purity at the main service panel. 2.
OPERATING INSTRUCTIONS Ensure the appliance Is connected to a properly grounded electrical outlet on a minimum 15 Amp circuit. if a new outlet Is required it should be installed by a qualified electrician according to applicable bulling codes. REMOTE CONTROL NOTE: If the fireplace does not respond fo the hand held control, see section A below The fireplace is supplied with a radio frequency remote contra. This remote control has a range of approximately 30 ft.
© NOU A BN Replacement Parts List Front Log Set Ember Bed Back Log Viewing Screen 120V Heater Assembly Projector Assembly Remote Receiver Remote Transmitter Power Assembly Bulb LED Assembly Front Screen Assembly Grate 4050-178 4050-113 4050-177 4050-144 4050-104 4050-002 4050-108 4050-105 4050-001 4050-123 4050-013 4050-008 4050-141 a 4050-281
HEARTHSTONE technologies” WARRANTY Hearth & Home Technologies inc. (HHT) Electric Fireplaces are tested and inspected prior 0 shipment and are guaranteed from deface io the purchaser of each new product. Any part which proves to be defective in material or workmanship under normal use within one year will be repaired or replaced without charge.” The Company will not be responsible for any expense incurred for installation, removal from service, or transportation costs.