¥ HEARTH HOME Owner’s Manual technologies’ Installation and Operation Electric Fireplace Models: OVERSIMPLIFY Series TUV LISTED AS MODEL BUILDER MODEL | “Ta, INSTALLED IN WOOD CABINET IDENTIFIED AS SF E-BWRC3530W BENTWOOD RED CHERRY AL SF E-BWRC3530W-M ~~ BENTWOOD RED CHERRY WITH MARBLE | .
Congratulations! Congratulations on selecting a Simplify electric fireplace: The unit you have selected Is designed to provide the utmost in safety, reliability and efficiency. The information contained in this owner's manual unless anted otherwise, applies to all models. Your new Oversimplify electric fireplace will give you As the owner of a new fireplace, you'll want to read and years of durable use and trouble-free enjoyment. carefully follow all of the instructions contained in this owner's manual.
A WARNING Firs Risk + Do not install or operate darn aged heater, + Do not modify heater, «+ Installation other than as instructed by Hearth & Home ‘Technologies Inc. is strictly prohibited. = Do not operate the heater without fully assembling all components. + Installation and/or use of any component part not approved by Hearth & Home Technologies. Hearth & Home Technologies disclaims any responsibility for, and the warranty and agency listing will be voided by the above actions.
UNPACKING THE UNIT WARNING: Do not use this fireplace If any part of i has been under water. Immediately call a qualified service technician to inspect and replace any parts of the electrical system if necessary, Carefully remove packaging from the unit, The front screen is held in place with clips.
SERVICE INSTRUCTIONS WARNING: Disconnect power at circuit breaker before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury. REPLACING THE LIGHT BULB This fireplace Uses a single 12 Volt, 35 Watt, MR-16 bulb, The bulb is located behind the smoke shield. 1. Turn off power to the unit at the main service panel. 2. Let the fireplace cool if it has been operating. 3. Release the spring pins and remove the upper shield. 4.
OPERATING INSTRUCTIONS Ensure the appliance is can nested to a properly grounded electrical outlet on a minimum 15 Amp circuit. If a new outlet Is required & should be Installed by & qualified electrician according to applicable building codes. REMOTE CONTROL NOTE: If the fireplace does not respond to the hand held control, see section A below The fireplace is supplied with a radio frequency remote control. This cremate control! has a range of approximately 30 ft.
Replacement Parts List 1 Front Log 4050-178 2 Ember Bed 4050-113 3 Back Log 4050-177 4 Viewing Screen 4050-144 5 120V Heater Assembly 4050-104 8 Projector Assembly 4050-002 7 Nonvoter Receiver 4050-108 8 Remote Transmitter 4080-108 9 Power Assembly 4050-001 10 Power Cord 4050-148 11 Bulb 4050-123 12 LED Assembly 4050-013 13 Front Screen Assembly 4050-008 14 Grate 4080-141 4050-260 7
HEARTHSTONE technologies” WARRANTY Hearth & Home Technologies Inc. (HHT) Electric Fireplaces are tested and inspected prior to shipment and are. guaranteed from deface to the purchaser of eds new product; Any part which proves fo be defective in material or workmanship under normal uss within one year will be repaired or replaced without charge* The Company will not be. responsible for any expense Incurred for installation, removal from service, or transportation costs.