TUV LISTED AS MODEL SFE-26C INSTALLED IN WOOD CABINET IDENTIFIED AS: SFE-MEDIA26-BK MEDIA CABINET BLACK SFE-CDLB26W CORTLAND LIGHT BROWN SFE-MKLB26W MACKINTOSH LIGHT BROWN SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Congratulations! Congratulations on selecting a Simplifyre electric fireplace. The unit you have selected is designed to provide the utmost in safety, reliability and efficiency. As the owner of a new fireplace, you’ll want to read and carefully follow all of the instructions contained in this owner’s manual. Pay special attention to all cautions and warnings. This owner’s manual should be retained for future reference. We suggest you keep it with your other important documents and product manuals.
IMPORTANT INSTRUCTIONS When using electrical heaters, basic precautions should • always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: • • • • • • • • • • • Read all instructions before using this heater. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater.
UNPACKING THE UNIT CORD ELECTRICAL CONNECTION WARNING Do not use this fireplace if any part of it has been under water. Immediately call a qualified service technician to inspect and replace any of the Carefully remove packaging from the unit. The front screen is held in place with four Phillips head screws. To remove the screen, extract the screws. Grasp the screen frame and pull out. LOCATING YOUR ELECTRIC FIREPLACE Your new electric fireplace may be installed virtually anywhere in your home.
OPERATING INSTRUCTIONS Ensure the appliance is connected to a properly grounded electrical outlet on a minimum 15 AMP circuit. If a new outlet is required, it should be installed by a qualified electrician according to applicable building codes. REMOTE CONTROL NOTE: if the fireplace does not respond to the hand held control see “Remote Control Initialization” below. This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules.
ELECTRICAL WIRING 1 5 SERVICE INSTRUCTIONS WARNING SCREEN CLEANING Disconnect power at circuit breaker before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury. During shipment, installation, handling, etc., the screen surface may collect dust particles; these can be removed by lightly wiping with a clean, dry cloth. REPLACING THE LIGHT BULB This appliance uses a single 12 Volt, 35 Watt, MR-16 bulb. The bulb is located behind the smoke shield.
Replacement Parts List 4050-311 Rev A 9/13/2007 1. Smoke Shield 4050-301 2. Back Log 4050-302 3. 120V Heater Assembly 4050-304 4. SFE-26C Installation Manual 4050-311 5. Remote Transmitter 4050-105 6. Front Log/Emberbed Assembly 4050-300 7. Remote Receiver 4050-108 8. Power Cord 4050-148 9. Power Assembly 4050-305 10. Optional Wall Switch 4050-309 11. Optional Wall Thermostat 4050-310 12. LED Assembly 4050-306 13. Bulb 4050-123 14. Projector Assembly 4050-312 15.
4050-311 Rev A 9/13/2007 8